Valcourt AC04347 User manual

Printed in Canada
CONSUMER: READ AND KEEP THIS MANUAL FOR REFERENCE
INSTALLER: LEAVE THIS MANUAL WITH THE COMPLIANCE.
46273A
2021-12-08
WARNING
If the information in these instructions are not
followed exactly, a re or explosion may result
causing property damage, personal injury or
loss of life.
— Do not store or use gasoline or other
ammable vapors and liquids in the
vicinity of this or any other appliance.
— WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your
building.
• Leave the building immediately.
• Immediately call your gas supplier
from a neighbor’s phone.
Follow the gas supplier’s
instructions.
• If you cannot reach your gas
supplier, call the re department.
— Installation and service must be
performed by a qualied installer,
service agency or the gas supplier.
WARNING
If not installed, operated and maintained
in accordance with the manufacturer’s
instructions, this product could expose you
to substances in fuel or from fuel combustion
which can cause death or serious illness.
DRIFTWOOD LOGS WITH EMBER AND BLACK
GLOWING WOOL
AC04347
FOR USE ON FG00002 AND FG00020 (SRF40) FIREPLACE
INSTALLATION INSTRUCTIONS
ENGLISH
NOTICE: Ceramic fiber logs
may differ in appearance from
those shown in this manual.
We suggest that our
gas hearth products be
installed and serviced
by professionals who
are certied in the U.S.
by the National Fireplace
Institute®(NFI) as NFI
Gas Specialists.
Safety tested
according to ANSI Z21.88-2017
and CSA 2.33-2017 standards
by an accredited laboratory.

Page 2 Installation Instructions - Driftwood Log Set
ENGLISH
AC04347 LOG SET IDENTIFICATION
INDEX LETTER
& DESCRIPTION
PART
NUMBER FRONT VIEW TOP VIEW
(1) REAR RIGHT
BOTTOM LOG 22454
(2) CENTER BOTTOM
LOG 22452
(3) REAR LEFT BOTTOM
LOG 22453
(4) FRONT RIGHT
CROSSOVER LOG 22459
(5) TOP LEFT
CROSSOVER LOG 22461
(6) BOTTOM RIGHT
CROSSOVER LOG 22460
(7) REAR LEFT
CROSSOVER LOG 22458
(8) FRONT LEFT
CROSSOVER LOG 22457
(9) FRONT BOTTOM
LOG 22462
(10) FRONT LEFT
SMALL BOTTOM LOG 22455
(11) FRONT SMALL
BOTTOM LOG 22456

Page 3
Installation instructions - Driftwood Log Set
ENGLISH
LOG INSTALLATION PREPARATION
The colors of the logs in the following images may differ from the driftwood
logs but the positioning of the logs remains the same.
LOG PLACEMENT
The positioning of logs is critical to safe and clean operation of this fireplace. Sooting and other
problems may result if the logs are not properly and firmly positioned in the fireplace.
BEFORE BEGINNING THE INSTALLATION:
1. Remove barrier screen and glass door on fireplace using instructions from the fireplace manual.
2. Install liners before logs. See separate liner installation manual for details.
3. Place logs in position as shown in Figure 1 and the following pages.
DO NOT force holes into the logs. Install using the holes located in each log.
Figure 1: Log placement

Page 4 Installation Instructions - Driftwood Log Set
ENGLISH
123
54
6
7
Figure 2: Pin Locations
Figure 3: Glowing embers placement
WARNING
Apply loose material (embers) per instruction manual. DO NOT apply extra material not
supplied with this appliance. All previously applied loose material (embers) must be
removed prior to reapplication. Do not cover large portswith loose material (embers).

Page 5
Installation instructions - Driftwood Log Set
ENGLISH
LOG SET PLACEMENT
STEP 1. Place LOG 2 onto burner base pins (4) and (5) located between the front and rear
burner tubes.
STEP 2. Place LOG 3 onto burner base pins (1) located to the left behind the rear burner.

Page 6 Installation Instructions - Driftwood Log Set
ENGLISH
LOG SET PLACEMENT
STEP 3. Place Log 1 to the right behind the rear burner onto burner base pins (2) and (3).
STEP 4. Place the glowing embers (A) on the top of the burner tubes, covering all ports. Then
place decorative rocks (B) alongside the front burner tube on the burner base. Do not cover the
burner tubes ports with decorative rocks. See figure 3 (page 4) for glowing embers placement
on the burners tubes.

Page 7
Installation instructions - Driftwood Log Set
ENGLISH
LOG SET PLACEMENT
STEP 5. Place LOG 10 and 11 to the left across the front burner tube.
STEP 6. Place Log 8 onto the lower left pin of Log 2.

Page 8 Installation Instructions - Driftwood Log Set
ENGLISH
LOG SET PLACEMENT
STEP 7. Place Log 7 onto the pin located on top left of the Log 2.

Page 9
Installation instructions - Driftwood Log Set
ENGLISH
LOG SET PLACEMENT
STEP 8. Place log 4 on top right of Log 1 and Log 2. Secure the bottom part of the log onto pin (7).
STEP 9. Place Log 5 on top of Log 7 and onto the pin of the Log 8. Secure the bottom part of
the log onto pin (6).

Page 10 Installation Instructions - Driftwood Log Set
ENGLISH
LOG SET PLACEMENT
STEP 10. Place Log 6 onto the pin on top right of Log 1.

Page 11
Installation instructions - Driftwood Log Set
ENGLISH
LOG SET PLACEMENT
STEP 11. Place Log 9 into the front recess of Log 2.

Stove Builder International inc.
250, De Copenhague street,
St-Augustin-de-Desmaures (Québec), Canada
G3A 2H3
418-908-8002
This document is available for free download on the
manufacturer’s website. It is a copyrighted document.
Resale is strictly prohibited. The manufacturer may update
this document from time to time and cannot be responsible
for problems, injuries, or damages arising out of the use
of information contained in any document obtained from
unauthorized sources.