Valor SFFK01 User manual

-ILES)NDUSTRIES,TD$OLLARTON(IGHWAY.ORTH6ANCOUVER"#6("
4ELOR &AXOR
WWWMILESFIREPLACESCOM
Model SFFK01
Freestyle Framing Kit
For use with 530 Model Heater
May 06
Mantel
Depth ‘A’ 2” 4” 6” 8” 12”
Mantel
Height ‘B’ 34” 36” 38” 40” 42”
The SFFK01 Freestyle Framing Kit is required when installing the StoneFire
series cast iron front or doors to a 530 model heater without a StoneFire mantel
(refer to separate SFMK01 instructions if using the stone mantel).
The Framing Kit, with heater attached, installs directly to studs at framing stage
with combustible wall nish applied afterwards. The framing kit may be installed
having between 1/2” and 2-1/2” projecting forward of the studs depending on
desired wall nish. Note—Bottom Panel will need to project further than sides to
support the Cast Fret when Alhambra doors are used.
Combustible wall nish may be installed around the perimeter of the framing kit as
shown but must not project forward of the front face of the framing kit.
The framing height shown includes the 1-1/2” high bottom base panel. The
framing height must be raised accordingly if you want the ooring material to run
beneath this base panel.
The heater and framing kit are approved to mount directly on hard surface
combustible ooring with no requirement for a non-combustible hearth in front.
•
•
•
•
•
Kit Components
General Concept
Framing Kit Dimensions
Framing Dimensions
Framing kit installed Flush Framing Kit Protruding
Combustible Mantel Clearances
Corner Dimension