Varan Motors WE-1 User manual

BCIE SARL
Gruuss-strooss 28, 9991 Weiswampach,Luxembourg
User manual

BCIE SARL
Gruuss-strooss 28, 9991 Weiswampach,Luxembourg
List of pieces (wall cabinet)
Couran
t Non.
Description
Bild/ picture
Quantity
1a
Left lateral plate
(standing in front of it)
1
1b
right lateral plate
(standing in front of it)
1
2
Back plate
1
3
Front frame
1
4
Top bottom
2
5
Trennwand
2
6
Door
2
7
Divide plate
2
8
Short door heel post
2

BCIE SARL
Gruuss-strooss 28, 9991 Weiswampach,Luxembourg
9
spacer for door heel
post
2
10
Wall nail
3
11
7-shaped door heel
post
2
12
Hanging angle
3
13
screws
32

BCIE SARL
Gruuss-strooss 28, 9991 Weiswampach,Luxembourg
1. Assembly
The following tools are recommended for assembly (not included).
Note:
Use only suitable tools during assembly and observe the safety instructions.
Wear work clothes (fitted outer clothing, work pants, gloves, work shoes and, if
necessary,
Safety glasses and respiratory protection).
Mount the wall cabinet
Step 1: mount the left side panel
a) Set up the left side panel and join it with the rear panel in the groove provided,
so that the rear panel and side panel form a line.
b) Now turn the left side wall 90 °vertically to the inside. Make sure that the
guide rails for the doors are inside!
Step 1 / picture 1 Step 2 / picture 2

BCIE SARL
Gruuss-strooss 28, 9991 Weiswampach,Luxembourg
Step 2: Assemble the right side wall, same procedure as step 1
a) Set up the left side panel and join it with the rear panel in the groove provided,
so that the rear panel and side panel form a line.
b) Now turn the left side wall 90 °vertically to the inside. Make sure that the
guide rails for the doors are inside!
See image from step 2
Step 3: Assemble the front frame, cover plate and base plate
a) Install the front frame using the enclosed self-tapping screws (picture 3)
b)Place the cover plate on the back and side walls. Make sure that the plate with
8 holes represents the upper part of the cabinet and must therefore be at the top.
(Picture 4)
Step 3 / picture 3 Picture 4
c) Now fix the 2 inner walls in the middle part of the wall unit using the self-
tapping screws (picture 5).

BCIE SARL
Gruuss-strooss 28, 9991 Weiswampach,Luxembourg
Picture 5 Step 4 / Picture 6
Step 4: assemble the doors
a) Insert the lower door bracket (1 piece) into the hole in the bottom bar. A
plastic washer is placed on this. (Picture 6)
1 piece
2 Piece
b) Place the door on the lower door bracket.
c) Align the door so that the hole in the door exactly matches the cover plate.
Now mount the upper door bracket. Note the following two pictures.
Back wall
Step 5: mount wall brackets
a) Fasten the cover plate to the wall with the included angles (3 pieces) and the
self-tapping screws (3 pieces) for later stabilization (for wall mounting 3 nails
available)

BCIE SARL
Gruuss-strooss 28, 9991 Weiswampach,Luxembourg
3 Piece
3 Piece
Picture 7 Picture 8
b) Connect attach shelves in the middle part of the cabinet (2 pieces)See picture
8