VelectriX Ascent+ 29 MTB User manual

Instruction Manual: VelectriX Ascent 29 MTB

Page 1
CONTENTS
Safe Riding Recommendations
Page 2
Pre-Ride Checklist
Page 3
Display and Controls
Page 4
Maintenance
Page 8
Warranty
Page 9
Contact Details
Page 10
Service Log
Page 11
Model Specification
Page 12

Page 2
Safe Riding Recommendations
1. Please ensure you are familiar with and follow all traffic laws
and regulations for your state. Please remember you may need
to review these when travelling interstate.
2. Always wear a helmet when riding your bike.
3. Don’t lend your bike to anyone who is unfamiliar with it.
4. As with all bikes it is important that you stay within safe limits
and speeds. If you feel you are travelling too quickly for the
road conditions, then slow down!! High speeds will increase
risk of injury in the event of an accident.
5. Please read and become familiar with the “Pre-Ride Checklist”
in this manual before riding your bike.
6. Switch the lights on your bike on when riding at all times of the
day or night. If your bike doesn’t have lights fitted as standard,
it is recommended that you purchase them and fit before
riding.
7. Your VelectriX bike must be returned to your servicing dealer
after 250kms or 6 weeks from date of purchase, whichever
comes first, to re-tension the spokes. Spokes should then be
re-tensioned every 1500kms.

Page 3
Pre-Ride Checklist
1. Check your bike for any loose nuts, bolts or fixings.
2. Check tyre pressures on your bike are correct. Please always
refer to the tyre manufactures suggested levels on the side of
the tyre. The following can be used as a guide only: Ascent 29
MTB (30-50psi).
3. Check the tyres on your bike for any visible damage, wear and
tear or bald spots.
4. Check that the brake levers have been installed correctly on
your bike. The left hand brake lever should operate the rear
brake and the right hand brake lever should operate the front
brakes.
5. Check the brakes are working effectively to stop your bike and
the power from the motor halts when the brakes are on.
6. Check that your bike is fitted with a working bell and reflectors.
7. Check that the wheel nuts or quick release skewers on your bike
are tight.
8. Check that the electronic functions on your bike are working.
9. Check that the handlebars and stem are tightened.
10. Check that all bags, baskets, boxes, etc. are securely fastened.
11. Check that your battery has sufficient charge for your ride.

Page 4
LCD Display and Controls
Turn On The LCD Display
Push and hold the POWER button, positioned on the top left hand side
of the LCD display, for 2 seconds, until the display lights up and switches
on.
Walk Mode
Press and hold the (DOWN) button and the bike will be powered to
6kph walking speed. Simply release the button to stop, this is a handy
function for walking with the bike up steep inclines.
Riding With Pedal Assisted Power
There are 5 pedal assist settings on this bike, level 1 being the slowest
speed and level 5 the fastest (level 1 pedal assist is automatically selected
when the display turns on). Simply push (UP) and (DOWN)
buttons to change between the levels. Pedal assist does not work in level 0
(zero). To stop the motor engaging, simply stop pedalling or pull on the
brake lever to engage the brakes.
Your electric bike is equipped with a LCD display, mounted on the left
side of the handlebar, and is controlled with 3 easy to use buttons
(POWER), (UP) and (DOWN).

Page 5
Automatic “Power Cut Off” Feature
This model is fitted with e-bike safety brake levers, which means that the
power to the motor will immediately disengage when either the left or right
hand side brake lever is used.
Other LCD Display Features
The LCD display, when turned on, will show speed, max speed, average
speed, odometer, trip meter, trip time, battery capacity and level of
assisted power (0-5). To change the information displayed (i.e speed,
odometer, trip meter) simply push the (POWER) button for 0.5
seconds. To reset the trip time and/or trip meter, hold the (UP) &
(DOWN) buttons together and then push (UP) button to select Y (yes)
and then to confirm data reset, push & hold (POWER) button for 2
seconds.

Page 6
Battery Instructions
Lock/Unlock Battery
This bike is supplied with a set of keys, which are needed to lock/unlock the
battery from the bike. The lock is located at the top of the battery on the
left hand side of the battery. To remove the battery, unlock the battery and
lift the battery upwards. When reattaching the battery make sure to lock
the base to avoid unnecessary power failures or damage.
Charging The Battery
You can charge the battery on or off the bike. Plug the battery charger
(supplied with this bike) into the charging port, located towards the bottom
on the right hand side of the battery. Once connected to the battery the
charger can then be turned on at the power socket. A GREEN light will
indicate when the battery is fully charged. Max charge time is 4 hours.

Page 7
The Battery Charger
ONLY use the battery charger supplied with this bike.

Page 8
Maintenance
1. Your VelectriX bike should be returned to your servicing dealer
for servicing and a thorough inspection once every 9 months or
1500kms, whichever comes first. Excluding the electronics,
motor, battery and wiring, your VelectriX bike is a normal bike,
with normal components. Your dealer will be able to explain to
you the general care and maintenance required for the
components of your bike.
2. Once a month lubricate all pivot points on your derailleur and
derailleur pulleys with suitable chain lube.
3. You can clean your bike with warm soapy water, however,
please do not submerge any electrical components or use a
high pressure hose. You can wipe dry the bike with a cloth.

Page 9
Warranty
All VelectriX bikes are covered by the following warranty and conditions
of use:
Battery
2 years
Motor
2 years
Frame
5 years
Other Components
1 year (excluding consumables: cables, tyres,
tubes, hand grips).
•The warranty is only valid for the first owner and is not
transferrable.
•The warranty commences from the date of purchase and proof of
purchase must be provided to cover any warranty parts.
•All commercial use is excluded.
•All Accidental damage is excluded.
•All damage caused from misuse is excluded.
•All repairs must be completed by a VelectriX dealer.
•The bike must be serviced every 1500kms or every 9 months,
whichever the sooner.

Page 10
Contact Details
If you have any questions, concerns or technical issues with any VelectriX
product please contact your VelectriX dealer immediately.
Dealer Name:
Dealer
Contact Number
Address
Sales Person
Sales Date
VelectriX Australian Service Centre Contact Details:
VelectriX Pty Ltd
Phone: [phone]
Visit: 10 Capital Place, Birtinya, Qld, 4575
Website: www.velectrix.com.au
Email: [email protected]

Page 11
Service Log
Date
Km
Notes
Next Service Due
Date: / / OR Km
Date
Km
Notes
Next Service Due
Date: / / OR Km
Date
Km
Notes
Next Service Due
Date: / / OR Km
Date
Km
Notes
Next Service Due
Date: / / OR Km
Date
Km
Notes
Next Service Due
Date: / / OR Km

Page 12
Model Specification
VelectriX Ascent 29 MTB
Frame: Aluminium VelectriX MTB
Size: Medium 45cm/large 50cm
Fork: Suntour XCR 32 front suspension
Colour: Satin black with blue & grey decals
Tyres: Kenda Nevegal Pro 29” x 2.20”
Brakes: Shimano mechanical discs
Gears: Shimano Deore 9
Motor: 36 volt 250 watt rear hub motor
Battery: 36 volt 11.6ah lithium ion
Battery Charger: Kushan ST Electronics Li-Ion STC-8118L. 2a 240V
Maximum Speed: 25 km/h
Weight: 20.5kgs (inc. battery)
Range:Up to 60kms
Carrying Capacity:110kgs (including battery, rider & accessories)