VelectriX Urban X User manual

VelectriX Instruction Manual
•Urban X
•Urban X Step Through

Page 1
CONTENTS
Safe Riding Recommendations
Page 2
Pre-Ride Checklist
Page 3
Display and Controls
Page 4 & 5
Battery Instructions
Page 6
Charger Instructions
Page 7
Maintenance
Page 8
Warranty
Page 9 -11
Model Specification
Page 12

Page 2
Safe Riding Recommendations
1. Please ensure you are familiar with and follow all traffic laws
and regulations for your state. Please remember you may need
to review these when travelling interstate.
2. Always wear a helmet when riding your bike.
3. Don’t lend your bike to anyone who is unfamiliar with it.
4. As with all bikes it is important that you stay within safe limits
and speeds. If you feel you are travelling too quickly for the
road conditions, then slow down!! High speeds will increase risk
of injury in the event of an accident.
5. Please read and become familiar with the “Pre-Ride Checklist”
in this manual before riding your bike.
6. Switch the lights on your bike on when riding at all times of the
day or night. If your bike doesn’t have lights fitted as standard,
it is recommended that you purchase them and fit before riding.

Page 3
Pre-Ride Checklist
1. Check your bike for any loose nuts, bolts, or fixings.
2. Check tyre pressures on your bike are correct. Please always
refer to the tyre manufactures suggested levels on the side of
the tyre.
3. Check the tyres on your bike for any visible damage, wear and
tear or bald spots.
4. Check that the brake levers have been installed correctly on
your bike. The left-hand brake lever should operate the rear
brake and the right-hand brake lever should operate the front
brakes.
5. Check the brakes are working effectively.
6. Check that your bike is fitted with a working bell and reflectors.
7. Check that the wheel nuts or quick release skewers on your bike
are tight.
8. Check that the electronic functions on your bike are working.
9. Check that the handlebars and stem are tightened.
10. Check that all accessories are securely fastened.
11. Check that your battery has sufficient charge for your ride.

Page 4
LCD Display and Controls
Turn On the LCD Display
To turn the bike on, push and hold the power button for 2 seconds, until the
display lights up and switches on. Do the same to turn the bike off. When
the display is turned on, it will show speed, odometer, trip meter, battery
capacity and level of assisted power PAS (0-3).
Power Assist Adjustment
There are 3 pedal assist riding settings, level 1 is the slowest (approx.
18kph), level 2 (approx. 25kph) and level 3 is the fastest (approx. 32kph).
Simply push the - (minus) and + (plus) buttons to change between the levels
of assist. Pedal assist does not work in level 0 (zero).
Light Operation
Press the Power button to turn the lights on and off.
Your electric bike is
equipped with a LCD display
unit, mounted in the middle
of the handlebar and a
separate controller on the
left hand side with 4
buttons: Power, Set, + (plus)
and –(minus)

Page 5
Walk Mode
Press and hold the –(minus) button for 2 seconds and the bike will be
powered to 6kph walking speed, simply release the button to stop. This is
NOT A RIDE function but is a handy function for walking with the bike up
steep inclines.
Reset Trip Meter
To reset the trip meter, hold the SET button for 2 seconds. A new screen
will now appear. Select the first option, “Trip Clear” and push the SET button
again and choose Y for yes or N for no. Now use the –(minus) button to go
to the last option “Save & Exit”and push SET again.
Adjusting Display Brightness
To adjust the brightness of the display, hold the SET button for 2 seconds.
A new screen will now appear. Select the last option “Brightness” and push
SET button again and choose your preferred brightness level, 5 being the
brightest and 1 being the lowest. Now use the –(minus) button again to go
to the last option “Save & Exit”and push SET again.

Page 6
Battery Instructions
Before riding you should check battery charge level by pressing the button
on the battery top. The battery charge light will illuminate. The colour of
the LED indicates the level of battery charge:
oBlue = More than 90% charge
oGreen = 40 –90% charge
oRed = 20 –40% charge
oFlashing Red = Less than 20% charge
Locking & Unlocking the Battery
The bike is supplied with a set of keys, that are required to remove the
battery from the bike. The lock is located at the top of the battery, in the
frame of the bike.
Removing the Battery from the Bike
To remove the battery, insert the key and turn fully clockwise. Pull the
battery straight up & out from the bike. When reinserting the battery,
place the base in first and push down gently on the top to engage the
lock. You will hear the lock “click” into place.
Always make sure the battery is securely locked in place before riding.

Page 7
The Battery Charger
Only use the battery charger supplied with this bike.
Charging the Battery
The battery may be charged on or off the bike.
1. Locate the charger port beneath the weather seal, on the top
of the battery.
2. Plug the battery charger into the charging port and wall power
socket.
3. Only when connected to the battery, should the charger be
turned on at the wall power socket.
4. When charging, both LED lights on the charger will be RED.
One of the lights will turn GREEN when the battery is fully
charged.
5. Charging time is around 4.5 hours.

Page 8
Maintenance
oYour VelectriX bike should be returned to your servicing dealer for
servicing and a thorough inspection once every 9 months or
1500kms, whichever comes first. Excluding the electronics, motor,
battery and wiring, your VelectriX e-bike is a normal bike, with
normal components. Your dealer will be able to explain to you the
general care and maintenance required for the components of your
bike.
oOnce a month lubricate the chain and all pivot points on your
derailleur and derailleur pulleys with suitable chain lube.
oYou can clean your bike with warm soapy water, however, please do
not submerge any electrical components or use a high pressure
hose. You can wipe dry the bike with a cloth.
oVelectriX encourages all owners to return their new VelectriX bike
to the place of purchase for a service/safety check, within the first
month or so of ownership.

Page 9
Warranty
This warranty is provided by VelectriX Pty Ltd. VelectriX warrants its
products, including all individual components against defects in material or
workmanship as follows:
Warranty Conditions
oThe warranty period is not renewed or extended as a result of a
warranty repair or replacement.
oThe sales receipt for the product must be provided as a proof of
purchase when a warranty claim is made.
oThe warranty is not transferable and is only offered to the original
purchaser of the product.
oThe warranty only applies to products purchased through a
VelectriX authorised reseller/dealer.
oAny approved warranty work must be completed by an authorised
VelectriX reseller/dealer.
oTo the extent that any conditions or warranty implied by law is
excludable, such a condition or warranty is excluded.
oThe warranted maximum combined carrying capacity for VelectriX
products is 110kgs (combined weight of rider & carried goods)
Frame Warranty
oVelectriX bicycle frames are warranted to be free from manufacture
defects in materials and/or workmanship for 5 years, from date of
original purchase.
Non-Electrical Component Warranty
The following non-electrical components are warranted to be free from
manufacture defects in materials and/or workmanship for a 1 year period
from the date of original purchase: fork, stem, handlebar, headset, seat
post, saddle, brake levers, brake callipers, brake rotors, bottom bracket,
crank set, pedals, rims, spokes, wheel hub, freewheel, cassette, derailleur,
gear shifter, kickstand, rack, mudguards.

Page 10
Electrical Component Warranty
The following electrical components are warranted to be free from
manufacture defects in materials and/or workmanship for a period of 2
years from the date of original purchase:
oMotor
oBattery
oController
The following electrical components are warranted to be free from
manufacture defects in materials and/or workmanship for a period of 1 year
from the date of original purchase:
oBattery charger
oWiring looms
oLight fittings/bulbs
oDisplay
oPAS sensor & cable
oGear shift sensor & cable
The battery warranty will exclude damage from:
oOver charging or power surges
oThe use of an improper, non-approved VelectriX charger
oAny other misuse, abnormal wear and tear, physical damage or
water damage
oAge related reduction in the capacity of the battery is normal and
unavoidable and as such does not constitute a fault. If the battery
has a capacity of at least 60% within 2 years of purchase it will be
considered acceptable. VelectriX reserves the right for the battery
to be returned for testing to establish the capacity before any repair
or replacement is authorised.

Page 11
Component Exclusions
The following components are deemed to be considered wear and tear items
and are NOT covered under this warranty:
oTyres and inner tubes/valves
oHead lights and tail lights
oMagnetic PAS sensor disc
oBrakes pads and cables
oDrivetrain components including chainrings, gear cassettes, chain,
gear cables and oils and lubricants.
Usage Exclusions
The following acts are not covered under warranty:
oDamage caused by acts of god
oDamage caused by improper use or force majeure
oDamage which results from improper or insufficient care
oRepairs, maintenance, alterations, modifications or the replacement
of parts by persons other than trained mechanics
oAny commercial use
oAccidental damage, neglect, abuse, misuse, repairs resulting from
the use of second hand parts
oDamage caused from competitive use, stunt riding or exceeding the
bikes carrying capacity.
How To Make a Warranty Claim
If you believe your VelectriX product is faulty or defective, please:
1. Contact the authorised VelectriX reseller/dealer from where the bike
was purchased and explain the issue.
2. The reseller/dealer with then advise as to how they will assist with
your warranty claim.

Page 12
Model Specification
VelectriX Urban X Mens
FRAME
Aluminium urban frame
COLOUR
Grey
SIZES
46cm
FORK
Suntour 27.5" 100mm travel suspension forks
TYRES
Kenda 27.5" x 2.2"
BRAKES
Tektro hydraulic. 180/160mm rotors
GEARS
Shimano 8-Speed
MOTOR
Dapu 300 watt, 36 volt mid drive unit with gear shift sensor
DRIVE TYPE
3 levels of pedal assist & walk assist mode
BATTERY
36v 13.6ah (490wh) frame integrated
CHARGER
Smart charger 36v 3A Single Pin
DISPLAY
LCD display unit
ACCESSORIES
Rear rack, kickstand, mudguards, front & rear lights
VelectriX Urban X Step Through
FRAME
Aluminium urban low step through frame
COLOUR
White
SIZES
39cm, 46cm
FORK
Suntour 27.5" 100mm travel suspension forks
TYRES
Kenda 27.5" x 2.2"
BRAKES
Tektro hydraulic. 180/160mm rotors
GEARS
Shimano 8-Speed
MOTOR
Dapu 300 watt, 36 volt mid drive unit with gear shift sensor
DRIVE TYPE
3 levels of pedal assist & walk assist mode
BATTERY
36v 13.6ah (490wh) frame integrated
CHARGER
Smart charger 36v 3A Single Pin
DISPLAY
LCD display unit
ACCESSORIES
Rear rack, kickstand, mudguards, front & rear lights