Victorian Plumbing Arezzo User manual

V2.12.23
Square Slide Rail Kit with
Shower Handset
Fitting Instructions
Please follow them carefully and
leave this manual with end user

V2.12.23
Installation Guide
Installation:
Attention: The working pressure of this product is between
1.0 - 8.0 bar
1. Identify all components are present prior to installation.
2. Install handset holder (2) onto the riser rail (1). Please be aware that the handset
holder (2) can move up and down the rail.
3. Place the two fixed bases (3) onto either end of the riser rail (1), see Figure 1.
4. Measure the reserved space for the shower kit.
5. Remove the covers on the fixed bases (3) and position the riser rail (1) and fixed
bases (3) on the wall at the desired height. Mark the screw holes with a pencil.
6. Using an appropriately sized drill bit, drill the marked holes and insert the wall
plugs (7) into the holes.
7. Place riser rail (1) and fixed bases (3) over the drilled holes, insert screws (6) and
tighten, see Figure 2.
8. Re-attach fixed base covers (3).
9. Connect the Shower hose (5) and shower handset (4) together using the G1/2”
thread.
10. Turn on the mains water supply, check all joints and connections for leaks.
11. The handset holder can now be moved to the desired height.
1. We recommend that this product is installed by a qualified tradesperson, Victorian
Plumbing Ltd. accept no liability for products incorrectly installed, or where the correct
testing procedures have not been adhered to, thus resulting in the escape of water and
consequential damage.
2. Ensure the incoming mains water supply is switched o prior to commencing the
installation.
3. Observe all local plumbing and building codes & regulations.
4. Unpack the product then read these instructions before proceeding. Inspect the product for
damage. If any damage is found, contact our Customer Relations team.
Before you begin:
Aftercare:
Always clean the surface of shower kit to keep it bright. Attention: please do not use
inappropriate tools such as sharp brushes, rough sponges, scouring pads or corrosive
detergent to clean the shower kit. Please clean the shower kit by wet cloth and soapy
water after each time of usage. Then rinse the soap out with clean water and dry
with a soft cotton cloth.

V2.12.23
1
2
4
5
6
7
3
1. Riser Rail
2. Handset Holder
3. Fixed Bases
4. Shower Handset
5. 1.5m Shower Hose
6. Screw
7. Screw Wall Plug

V2.12.23
www.victorianplumbing.co.uk