Victorian Plumbing Arezzo User manual

V2.12.23
Fitting Instructions
Please follow them carefully and
leave this manual with end user
Stone Wall Hung Basin with
Mounting Bracket

V2.12.23
Tools Required (Not Included):
Damp ClothSilicone Sealant
1. We recommend that this product is installed by a qualified tradesperson, Victorian
Plumbing Ltd. accept no liability for products incorrectly installed or any damage to the
floor, walls, plumbing, vanity cabinet, sink, counter top, or personal injury during installation.
2. Observe all local plumbing and building codes & regulations.
3. Attention: The sink must be fastened to load bearing wall.
4. Ensure the incoming mains water supply is switched o prior to commencing the
installation.
5. For the following instructions, it is assumed that the in-wall plumbing has already been
prepared.
6. Unpack the product then read these instructions before proceeding. Inspect the product for
damage. If any damage is found, contact our Customer Relations team.
Before you begin:
Pencil Tape Measure Power Drill Spirit Level
Spanner Rubber Hammer
Items Included:
No. Description Picture Qty
A Basin 1
BWaste & Waste-
Pipe 1
CMounting
Bracket 1
D Steel Rawl Bolt 4

V2.12.23
Step 1:
Step 2:
Step 3:
Hold the bracket up at the desired installation location. Ensure that the bracket is
level, then mark the location of the anchor holes.
Move the sink away from the installation location. For convenience, install the waste
onto the sink before moving on. Carefully drill the holes for the rawl bolts ensuring
the correct sized masonry bit is used and insert the rawl bolt using a rubber
hammer.
Place the mounting bracket into position and tighten with a spanner. Using a
spirit level re-check to ensure the brackets are level. Make sure that the mounting
bracket is securely fixed to the wall before proceeding with mounting the basin.
Apply a bead of good quality silicone sealant along the bracket supporting arms.
WALL
Installation:

V2.12.23
Step 4:
Step 5:
Pipe a bead of good quality silicone sealant along the rear of the basin. Place the
basin onto the bracket while pushing the basin back against the wall and wipe
away the excess silicone with a damp cloth. Ensure that the basin is level using a
spirit level.
Allow the sealant to fully dry for 24 hours. Proceed to the installation of the drain
trap, water supply lines. Refer to their respective installation instructions for
guidance if needed.
24hr
Cleaning and Maintenance:
We recommend that you regularly clean your stone sink with a mild dish detergent
or stone cleaner. After each use, wipe the basin dry with a soft cloth. Do not allow
mineral deposits such as iron, salt, lime, or soap to build up on your sink. Refrain
from using acidic household cleaners, wipes with harsh chemicals, or abrasives, as
these will damage stone.
www.victorianplumbing.co.uk