Victorian Plumbing bower User manual

Fitting Instructions
Please follow them carefully and
leave this manual with end user
V1.10.23
Universal Basket
Strainer Waste

V1.10.23

V1.10.23
Unpack the product then read these instructions before proceeding. And Inspect the
universal basket strainer waste for damage. If any damage is found, contact our Customer
Relations team.
1. Make sure all components are present prior to installation
2. Unscrew the screw (1), then remove the overflow cover (2) and rubber washer (3).
3. Remove the waste strainer (13) and screw (12), then place the flange (11) and
Foam washer (10) above the sink hole. Attach the Rubber Washer (9) and Waste body (8)
to the underneath of sink. (Please note the washer can’t be put askew.) Then tighten the
screw (12). As shown in the diagram.
4. Install the overflow elbow (4) and rubber washer (3) on the overflow hole of sink as
shown in the diagram. Then place the overflow cover (2) on the overflow hole of sink,
tighten the screw (1).
5. Connect the plastic tube (5) with the outlet of overflow elbow (4).
Make sure the plastic tube can not slip o. Then put the other side of plastic tube (5) into
the waste body (8), install the sealing ring (7). Tighten the plastic nut (6).
6. Place the Waste strainer (13) into the Screw (12).
7. Check all joints and connections for leaks after finish the installation.
Before you begin:
Assembly:
Assembly instructions
Note: Round overflow cover (14) can be exchanged with Rectangular overflow cover (2) according to
your needs.
If do not need to install the overflow parts and tube, the plastic washer and rubber washer need to be
installed onto the waste body, then tighten the plastic nut (6), plug the drain hole, as shown in below
diagram.