ViewZ VZ-CM-V3 User manual

INSTALLATION MANUAL
Flat Panel Ceiling Mount Accessory
ISSUED: MAR. 2013
7
200x200/300x300
400x200/400x400
600x400/800x400
65"
MAX

21
NOTE: Read the entire instruction manual before you start installation and assembly. Component Checklist
WARNING
• Do not begin the installation until you have read and understood all the instructions
and warnings contained in this installation sheet. If you have any questions
regarding any of the instructions or warnings, please contact your local distributor.
• This mounting bracket was designed to be installed and utilised ONLY as
specified in this manual. Improper installation of this product may cause damage
or serious injury.
• Always use an assistant or mechanical lifting equipment to safely lift and position
the equipment.
• Tighten screws firmly, but do not over tighten. Over tightening can cause damage
to the items, This greatly reduces their holding power.
• This product is intended for indoor use only. Using this product outdoors could
lead to product failure and personal injury.
IMPORTANT: Ensure that you have received all parts according to the component checklist prior to installation.
If any parts are missing or faulty, telephone your local distributor for a replacement.
Package M
universal plate (x1)
A
adapter bracket (x2)
B
M5x14 (x4)
M-A
M6x14 (x4)
M-B
washer
M-F
(x4)
M8x20 (x4)
M-C
big spacer (x4)
M-H
M6x30 (x4)
M-D
M8x30 (x4)
M-E
small spacer (x8)
M-G
antiskid block (x2)
C
set screw(x1)
D
Allen key (x1)
E

43
TV
TV
TV
1. Installing the Adapter Brackets
2. Attaching the Universal Plate to the Pipe
1-2 For Recessed Back Screens or to Access A/V Inputs
TV
TV
TV
Tighten all screws but do not over tighten.
· Position the adapter brackets as close as possible to the center of the display.
· Screw the adapter brackets onto the display.
Note: Choose the appropriate screws, washers and spacers (if necessary) according to the type of screen.
1-1 For Flat Back Screens
1-1/2" internal diameter
Thread and tighten the universal plate
onto the pipe(not included).
Insert and tighten one set screw to
secure it.
DE
M-A
M-B
M-C
M-F
M-D
M-E
M-F
M-H
M-G
M-D
M-E
M-F
M-H
M-C
M-D
M-E
M-F
M-G
M-G
M-C
M-F
M-G
Top of the Display

4. Adjustment
Maintenance
• Check that the bracket is secure and safe to use at regular intervals(at least every three months).
• Please contact your distributor if you have any questions.
+5°
-12°
3. Hooking the Display onto the Wall Mount
6
5
Install both antiskid blocks as close to the adapter brackets as possible.
C
C
Tighten all screws on the antiskid blocks using a proper screwdriver to prevent the display from moving.
+5° -5°
Tighten the bottom bolts to secure the adapter brackets to the universal plate.
Adjust the display to the desired angle.