Viking Designer DETU200-4B User manual

Viking Installation Guide
Designer Built-In
Electric Cooktops

Table of Contents
Warnings & Important Safety Instructions _______________________________________________3
Dimensions (30”) ____________________________________________________________________6
Dimensions (36”) ____________________________________________________________________7
Specifications _______________________________________________________________________8
Cutout Dimensions __________________________________________________________________9
Downdraft Dimensions ______________________________________________________________9
Clearance Dimensions (Proximity to Cabinets)___________________________________________9
Clearance Dimensions (Wood/Composite or Steel Overlay)______________________________11
Electrical Requirements _____________________________________________________________12
General Information ________________________________________________________________14
Installation_________________________________________________________________________15
Electrical Connection ____________________________________________________________16
Final Installation ________________________________________________________________16
Final Preparation ___________________________________________________________________17
Performance Checklist ______________________________________________________________17
Service & Registration_______________________________________________________________18

IMPORTANT
• Before beginning read these instructions
thoroughly and carefully.
• Installation and service must be performed by
a qualified installer service agency.
•DO NOT remove permanently affixed labels
warnings or plates from the product as this
may void the warranty.
• Observe all local and national codes
requirements and ordinances.
• Write down the model and serial numbers
before installing the cooktop. Both numbers
are on the serial rating plate located on
bottom of cooktop box.
• Installation must conform with local codes or in
the absence of codes the national electric
code: ANSI/NFPA 70-latest edition** or CSA
standards C22. 1-94 Canadian Electrical Code
part No. 0-M91 - latest edition*** and all local
codes and ordinances.
In Canada: Installation must be in accordance
with the current CAN/CGA B149.1 & 2 Gas
Installation codes and with the current CSA C22.1
Canadian Electrical Codes Part 1 and/or local
codes.
Copies of the standards listed may be obtained
from:
** National Fire Protection Association One
Batterymarch Park Quincy Massachusetts 02269
*** CSA International 8501 East Pleasant Valley
Rd. Cleveland OH 44131-5575
• Installers should leave these instructions with
the consumer who should retain them for the
local inspector’s use and for future reference.
3
–Please Read and Follow
Your safety and the safety of others is
very important.
We have provided many important safety
messages in this manual and on your
appliance. ALWAYS read and obey all
safety messages.
This is the safety alert symbol. This
symbol alerts you to hazards that
can kill or hurt you and others.
All safety messages will be preceded by
the safety alert symbol and the word
“DANGER,” “WARNING” or “CAUTI N.”
These words mean:
Hazards or unsafe practices
which WILL result in severe personal
injury or death
DANGER
Hazards or unsafe practices
which COULD result in severe personal
injury or death
Hazards or unsafe practices which
COULD result in minor personal injury
or property damage.
All safety messages will identify the
hazard, tell you how to reduce the chance
of injury, and tell you what can happen if
the instructions are not followed.
WARNING
CAUTION

IMPORTANT
4
–Please Read and Follow
FIRE/EXPLOSION
HAZARD
IF THE INF RMATI N IN
THIS MANUAL IS N T
F LL WED EXACTLY, A FIRE R
EXPL SI N MAY RESULT CAUSING
PR PERTY DAMAGE, PERS NAL
INJURY, R DEATH.
•DO NOT store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
DANGER
ELECTRICAL GROUNDING
INSTRUCTIONS
The cooktop must be electrically grounded
in accordance with local codes or, in the
absence of codes, with the ANSI/NFPA
No. 70-latest edition. Installation should
be made by a licensed electrician. This
appliance is equipped with a three-prong
grounding plug for your protection against
shock hazard and should be plugged
directly into a properly grounded
receptacle. DO NOT cut or remove the
grounding prong from the plug.
For personal safety, this appliance
must e properly grounded. DO NOT
under any circumstances cut or
remove the third (ground) prong from
the power plug.
WARNING
BURN HAZARD
The use of cabinets for storage above the
appliance may result in a potential burn
hazard. Combustible items may ignite,
metallic items may become hot and
cause burns. If a cabinet storage is to be
provided the risk can be reduced by
installing a range hood that projects
horizontally a minimum of 5” (12.7 cm)
beyond the bottom of the cabinets.
CAUTION

IMPORTANT
5
–Please Read and Follow
This appliance shall not be used for
space heating. This information is based
on safety considerations.
WARNING
SITE PREPARATION
It is recommended that a thorough site
inspection be conducted PRIOR to
unpacking and moving this appliance.
WARNING
It is the customer's responsibility to
contact a qualified electrical installer. To
assure that the electrical installation is
Adequate and in conformity with national
electrical code: ANSI/NFPA 70-latest
edition** or CSA standards C22.1-94,
Canadian Electrical Code, part No.0-M91
- latest edition*** and all local codes and
ordinances.
WARNING
THE CONDUIT IS 3 FEET LONG
The junction box must be located where it
will allow considerable slack in the
conduit for serviceability.
WARNING

Dimensions
6
21”
(53.3 cm)
30-3/4”
(78.1 cm)
3-1/8”*
(7.9 cm)
4-1/4”
(10.8 cm)
28”
(71.1 cm)
18-9/16”
(47.2 cm)
12”
(30.5 cm)
3-1/4”
(8.3 cm)
Power
conduit
30” Electric Cooktop
*Note: Dimension includes screw head.

Dimensions
7
21”
(53.3 cm)
3-1/8”*
(7.9 cm)
4-1/4”
(10.8 cm)
36-3/4”
(93.4 cm)
33-3/8”
(84.7 cm)
18-9/16”
(47.2 cm)
3-1/4”
(8.3 cm)
Power
conduit
12”
(30.5 cm)
36” Electric Cooktop
*Note: Dimension includes screw head.

Specifications
8
Designer Electric Cooktops
Description
DETU 00-4B DETU 60-5B
Overall width 30-3/4” (78.1 cm) 36-3/4” (93.3 cm)
Overall height (from top of
cooktop to bottom of conduit)
4-1/4” (10.8 cm)
Overall depth from rear 21” (53.3 cm)
Cutout width 28-3/4” (72.9 cm) min. to
29” (73.7 cm) max.
34” (86.4 cm) min. to
34-9/16” (87.8 cm) max.
Cutout height 3-1/8” (7.9 cm)
Cutout depth 19-1/4” (49.0 cm) min. to
19-5/8” (49.8 cm)
Electrical requirements 3-wire 240-208/120VAC/60Hz;
40 amp connection. Unit is equipped with
No. 10 ground wire in conduit. Should be fused
separately.
3-wire 240-208/120VAC/60Hz;
60 amp connection. Unit is equipped with
No. 10 ground wire in conduit. Should be fused
separately.
Maximum amp usage 240V—35.0 amps (8.4 kw)
208V—30.3 amps (6.3 kw)
240V—45.0 amps (10.8 kw)
208V—40.0 amps (8.3 kw)
Surface element rating
Left front
Bridge
Left rear
Center
Right front
Right rear
2 0V 208V
1 800 watts 1 350 watts
800 watts 600 watts
1 800 watts 1 350 watts
1 500 watts 1 125 watts
N/A N/A
2 500/1 600/800 watts 1 875/1 200/600 watts
2 0V 208V
1 800 watts 1 350 watts
800 watts 600 watts
1 800 watts 1 350 watts
2 500/1 600/800 watts 1 875/1 200/600 watts
1 500 watts 1 125 watts
2 100 watts 1 575 watts
Approximate
shipping weight 35 lb. (13.1 kg) 60 lb. (27.2 kg)

9
A
B
Note: Based on 24” deep cabinet with /4” backsplash.
DETU 00 DETU 60
A 28-3/4” (72.9 cm) min. to
29” (73.7 cm) max.
34” (86.4 cm) min. to
34-9/16” (87.2 cm) max.
B 19-1/4” (49.0 cm) min. to
19-5/8” (49.8 cm) max.
Cutout Dimensions
Note: Refer to the downdraft installation instructions.
Downdraft Dimensions
DETU 00 w/DIPR100 DETU 60 w/DIPR160
A 28-3/4” (73.0 cm) 34” (86.4 cm)
B 20-1/4” (51.4 cm)
C 27 (68.6 cm) 33” (84.0 cm)
D 2-1/4” (5.7 cm)
E 7/8” (1.9 cm) 7/8” (1.9 cm)
F 7/8” (1.9 cm) 7/8” (1.9 cm)
C
EF
D
A
B

Clearance Dimensions (Proximity to Cabinets)
30” min.
(76.2 cm)
13” max.
(
33.0 cm)
6” min.
(15.2 cm)
18” min.
(45.7 cm)
36” min.
(
91.4 cm)
1-1/2” min.
(3.8 cm)*
2-1/2” min.
(6.35 cm)*
Note: Dimensions shown are for use with
combustible surfaces unless otherwise stated.
Proximity to Side Cabinet Installation
• The cooktop may be installed directly to
existing base cabinets.
• The cooktop CANNOT be installed directly
adjacent to sidewalls tall cabinets tall
appliances or other side vertical surfaces
above 36” (91.4 cm) high. There must be a
minimum of 6” (15.2 cm) side clearance from
the cooktop to such combustible surfaces
above the 36” (91.4 cm) counter height.
• Within the 6” (15.2 cm) side clearance to
combustible vertical surfaces above
36” (91.4 cm) the maximum wall cabinet
depth must be 13” (33.0 cm) and wall cabinets
within this 6” (15.2 cm) side clearance must be
18” (45.7 cm) above the 36” (91.4 cm) high
countertop.
• Wall cabinet above the cooktop must
be a minimum of 30” (76.2 cm) above the
countertop for a full width of the cooktop.
This minimum height requirement does not
apply if a rangehood is installed over the
cooking surface.
Minimum Clearances from Adjacent
Combustible Construction
• Wall cabinets directly above the product must be
minimum 30” (76.2 cm) above the countertop
• Sides—minimum 6” (15.2 cm)
• Rear—minimum 1-1/2” (3.8 cm)
• From edge of cutout and front edge of
countertop 2-1/2” (6.35 cm)
• Within 6” (15.2) side clearance; wall cabinets
no deeper than 13” (33.0 cm)
• Countertop depth 25” (63.5 cm)
• Overhead cabinet depth from rear maximum
13” (33.0 cm)
• Side cabinet height from countertop
minimum 18” (45.7 cm)
10