Viking Hid-2 Instructions for use

TECHNICAL

Keypad for Entry Systems

The HID-2 Keypad with Wiegand output allows keyless entry for select

Viking apartment or office entry systems. The HID-2 Keypad features

standard 26-bit Wiegand interfacing, a metal enclosure with potted

electronics and a pigtail connection for indoor or outdoor applications.

The Keypad interfaces with the AES-2000 Accessible Entry System.

Up to 32 entry points with HID-2 Keypads may be added to the AES-

2000.

Alternatively, the HID-2 can be used with the ES-1 Stand Alone Door

Entry Controller, and the C-4000 Four Door Entry Controller.

The HID-2 is equipped with Enhanced Weather Protection (EWP) for

outdoor installations where the unit is exposed to precipitation or con-

densation. The HID-2 features a foam rubber gasket, sealed connec-

tions, as well as an epoxy potted circuit board. For more information,

see DOD# 859.

• Standard 26-bit Wiegand interface

• Designed for outdoor use, the HID-2 comes

standard with Enhanced Weather Protection

(EWP)

• HID-2 is designed to meet IP66 Ingress

Protection Rating (see DOD# 859)

• Pigtail connection for easy installation

• Bi-color LED shows activity

• Screw protection caps

• Beep tones acknowledge key strokes

• Programmable Facility Code stored in non-

volatile memory (no batteries required)

Power: 12-28V DC, 30mA - average

Dimensions: 181mm x 43mm x 20mm (7.1” x 1.7” x 0.5”)

Shipping weight: 0.45 kg (1 lb)

Environmental: -40° C to 70° C (-40° F to 158° F) with up to

100% humidity

Connections: 8” long pigtail leads, 22 gauge

HID-2

Keypad with

Wiegand Output

May 8, 2012

• Compatible with Viking’s AES-2000 Accessible

Entry System (see DOD# 202)

• Compatible with Viking’s C-4000 Apartment/

Office Entry Controller (see DOD# 164)

• Compatible with Viking’s ES-1 Stand Alone

Door Entry Controller (see DOD# 193)

• Compatible with Viking’s ES-3 Entry System

Door Controller (see DOD# 195)

Due to the dynamic nature of the product design, the information contained in this document is subject to change without notice. Viking Electronics, and its affiliates and/or subsidiaries

assume no responsibility for errors and omissions contained in this information. Revisions of this document or new editions of it may be issued to incorporate such changes.

DOD# 199

ZF301970 Rev C

Printed in the U.S.A.

IF YOU HAVE A PROBLEM WITH A VIKING PRODUCT, PLEASE CONTACT: VIKING TECHNICAL SUPPORT AT (715) 386-8666

Our Technical Support Department is available for assistance weekdays between 8 a.m. and 5 p.m. central time. So that we can give you better service, before you call please:

1. Know the model number, the serial number and what software version you have (see serial label).

2. Have your Technical Practice in front of you.

3. It is best if you are on site.

RETURNING PRODUCT FOR EXCHANGE

The following procedure is for equipment that has failed out-of-box (within 10 days of purchase):

1. Customer must contact Viking’s Technical Support at 715-386-8666 to determine possible causes for the problem. The

customer MUST be able to step through recommended tests for diagnosis.

2. If the Technical Support Product Specialist determines that the equipment is defective based on the customer's input

and troubleshooting, a Return Authorization (R.A.) number will be issued. This number is valid for fourteen (14)

calendar days from the date of issue.

3. After obtaining the R.A. number, return the approved equipment to your distributor, referencing the R.A. number. Your

distributor will then replace the product over the counter at no charge. The distributor will then return the product to

Viking using the same R.A. number.

4. The distributor will NOT exchange this product without first obtaining the R.A. number from you. If you haven't

followed the steps listed in 1, 2 and 3, be aware that you will have to pay a restocking charge.

RETURNING PRODUCT FOR REPAIR

The following procedure is for equipment that needs repair:

1. Customer must contact Viking's Technical Support Department at 715-386-8666 to obtain a Return Authorization (RA)

number. The customer MUST have a complete description of the problem, with all pertinent information regarding the

defect, such as options set, conditions, symptoms, methods to duplicate problem, frequency of failure, etc.

2. Packing: Return equipment in original box or in proper packing so that damage will not occur while in transit. Static

sensitive equipment such as a circuit board should be in an anti-static bag, sandwiched between foam and individual-

ly boxed. All equipment should be wrapped to avoid packing material lodging in or sticking to the equipment. Include

ALL parts of the equipment. C.O.D. or freight collect shipments cannot be accepted. Ship cartons prepaid to:

Viking Electronics, 1531 Industrial Street, Hudson, WI 54016

3. Return shipping address: Be sure to include your return shipping address inside the box. We cannot ship to a PO Box.

4. RA number on carton: In large printing, write the R.A. number on the outside of each carton being returned.

Black

Red

Green

White

Violet

GND

12-28V DC

Data 0

Data 1

Earth

Ground

To Viking

product

Note: Keep unused

leads from shorting.

AES-2000 ES-1

C-4000 ES-3

The red LED on the front of the HID-2 will light steady to show the keypad is powered up, and blink yellow with each key stroke. A beep

tone will also acknowledge each time a key is pressed. To gain access, enter the keyless entry code, followed by the “#” key.

Important: 26-bit Wiegand data limits the entry code range from 00001 to 65534.

Warning: Do not program the Viking ES-1, C-4000, AES-2000 or any other entry system to accept code number 65535. The HID-2 key-

pad outputs 65535 as an error code. An error code is given if one of these three sequences happen:

1. Pressing the “#” key with no preceding digits.

2. Pressing any number of only zeros prior to pressing the “#” key.

3. Pressing 65535 or any number above 65535.

The HID-2 is factory programmed with the facility code cleared (000). To program a facility code, press “Q” during the first 3 seconds from

when the unit powers up. Then (within 10 seconds) enter any number 000 to 255 as its facility code, followed by “#”.

IMPORTANT: Electronic

devices are susceptible

to lightning and power

station electrical surges from both

the AC outlet and the telephone

line. It is recommended that a

surge protector be installed to pro-

tect against such surges.

LIMITED WARRANTY

Viking warrants its products to be free from defects in the workmanship or materials, under normal use and service, for a period of one year from the date of purchase from any authorized Viking distributor or 18 months from the date manu-

factured, which ever is greater. If at any time during the warranty period, the product is deemed defective or malfunctions, return the product to Viking Electronics, Inc., 1531 Industrial Street, Hudson, WI., 54016. Customer must contact Viking's

Technical Support Department at 715-386-8666 to obtain a Return Authorization (R.A.) number.

This warranty does not cover any damage to the product due to lightning, over voltage, under voltage, accident, misuse, abuse, negligence or any damage caused by use of the product by the purchaser or others. This warranty does not cover

non-EWP products that have been exposed to wet or corrosive environments.

NO OTHER WARRANTIES. VIKING MAKES NO WARRANTIES RELATING TO ITS PRODUCTS OTHER THAN AS DESCRIBED ABOVE AND DISCLAIMS ANY EXPRESS OR IMPLIED WARRANTIES OR MERCHANTABILITY OR FIT-

NESS FOR ANY PARTICULAR PURPOSE.

EXCLUSION OF CONSEQUENTIAL DAMAGES. VIKING SHALL NOT, UNDER ANY CIRCUMSTANCES, BE LIABLE TO PURCHASER, OR ANY OTHER PARTY, FOR CONSEQUENTIAL, INCIDENTAL, SPECIAL OR EXEMPLARY DAM-

AGES ARISING OUT OF OR RELATED TO THE SALE OR USE OF THE PRODUCT SOLD HEREUNDER.

EXCLUSIVE REMEDY AND LIMITATION OF LIABILITY. WHETHER IN AN ACTION BASED ON CONTRACT, TORT (INCLUDING NEGLIGENCE OR STRICT LIABILITY) OR ANY OTHER LEGAL THEORY, ANY LIABILITY OF VIKING SHALL

BE LIMITED TO REPAIR OR REPLACEMENT OF THE PRODUCT, OR AT VIKING'S OPTION, REFUND OF THE PURCHASE PRICE AS THE EXCLUSIVE REMEDY AND ANY LIABILITY OF VIKING SHALL BE SO LIMITED.

IT IS EXPRESSLY UNDERSTOOD AND AGREED THAT EACH AND EVERY PROVISION OF THIS AGREEMENT WHICH PROVIDES FOR DISCLAIMER OF WARRANTIES, EXCLUSION OF CONSEQUENTIAL DAMAGES, AND EXCLU-

SIVE REMEDY AND LIMITATION OF LIABILITY, ARE SEVERABLE FROM ANY OTHER PROVISION AND EACH PROVISION IS A SEPARABLE AND INDEPENDENT ELEMENT OF RISK ALLOCATION AND IS INTENDED TO BE ENFORCED

AS SUCH.

Other manuals for HID-2

Table of contents

Other Viking Keypad manuals