Vikre Handel AS JIT-1216 User manual

SHELTER
MODEL: JIT-1216
L4.8xW3.66xH2.6M
www.vikre.no
Assembly Manual

Assembly Illustration
For “User Friendly” assembly we have identified each
individual component with our part code number as indicated in
part list. Please refer to the part code numbers and drawings to
ensure problem free assembly.
READALL INSTRUCTIONS BEFORE ASSEMBLY
1. Keep work area clean. Cluttered areas invite injuries.
2. Be aware of your surroundings and leave enough workspaces. Do not set
up near snowdrifts, in slippery places, in high winds, or wet waterlogged
location.
3. Keep children away. All children should be kept away from the work area.
4. Don’t over reach. Keep proper footing and balance at all times.
5. Do not assemble if under the influence of alcohol or drugs.
6. Be aware of possible windy conditions. Consider removing the cover in
severe windy conditions.
7. Clean off snow before entering. Do not allow snow to sit for extended
period of time.
8. Be careful of the frame. Do not hang anything other than included parts
from the frame. Do not hang from or pull on the tubes. Do not climb on the
frame. Do not alter the frame in any way.
9. Be careful with power and heat sources. Do not keep heat sources near the
tarpaulin. Do not expose to open flame.
10.Be aware of personal safety during assembly and use. Be careful not to
pinch fingers by clips and tubes when assembling.
11.Make sure there is adequate ventilation for exhaust and other dangerous
fumes.

Part code Description Quantity
R Base rail in the corner 2
L Base rail in the corner 2
M Base rail in the middle 2
1 Curved 3 way fitting 2
2 Curved 4 way fitting 3
3 Straight 3 way fitting 4
4 Straight 4 way fitting 6
5 Curved roof tubing at the ends 4
5B Curved roof tubing in the middle 6
6 Horizontal tube and roof purlin 12
7 Vertical side wall tube 10
8 Cross braces for suspending door tarp 2sets
9 Cross braces 5
10 Connection plate for base rail 4
11 Base rail cross bracket for each end (2pcs.per set) 2sets
11A Base rail cross bracket for center (2pcs.per set) 1set
12 Bolts for base rail cross bracket 6
13 Bolts for base rail 20
14 Stake peg 27
15 Hooks for roof cover tensioning 4
16 Tie down ratchet 10
17 Plastic cap in base rail end 4
18 Bolts for cross tube and slanting support tube connection 22
19 Roof cover 1
20 Lower roof cover tensioning tube 2sets
21 Band for tie down ratchet 10
22 Top flap above the door 2
23 Door Cover 2
24 "S" hook 16
25 Elastic ball bungee connectors 40
26 Reinforcing snaps for zipper door 4
28 Bolts for tie down ratchet 20
29 Plastic cap for tensioning tube 4
31 Slanting support tube 4
32 Tube clip for slanting support tube 8
Part list of 12'x16'