Viper AS4325B User guide

Start cleaning by placing the hands on the
safety switches
Use and maintenance
Operating guidelines AS4325B
July 2020
Turn on the machine and verify there is
enough battery power to complete the
work. Charge batteries if required.
Lift the deck by pressing the pedal Place the brush or the pad-holder under the
deck and Lower the deck or the brush/pad-
holder by pressing the pedal
With the machine on, press one of the safety switches to engage the brush/pad-holder, then
release it. If necessary, repeat the procedure until the brushes/pad-holder is engaged.
The squeegee is raised and lowered with the deck.
Check the solution level the red ball on the
left side of the machine.
Lift the squeegee up by hand until it locks in
up position and turn suction off for double
scrubbing. To go back to working mode,
use the red lever to release the squeegee.
and turn suction on again.
Press the + or – buttons to increase /
decrease the solution ow rate.
Remove the red cover, ll the tank with
clean water and use maximum temperature
40 degree. Add appropriate low foaming
detergent according to dosage information.
When scrubbing is complete, turn off
the machine to perform the following
maintenance

Maintenance
Operating guidelines AS4325B
July 2020
When scrubbing is complete, turn off the
on/off button to perform the following
maintenance.
Daily: Empty the clean water tank using
the solution tank drain knob under the
machine.
Daily: Empty the recovery tank using the
recovery empty hose. Bend the soft part
before removing the cap to control the
ow.
Daily: Inspect and rinse the oat ball cage
and inspect and clean the lid gasket if
required.
Local Viper dealer:
Phone number:
SN:
Daily: Remove the squeegee, and clean.
Inspect the blades and ip them or replace
them if required.
Daily: Leave the recovery tank lid open to
let the tank dry after it’s been cleaned to
avoid bad odor.
Daily: With the machine turned on and
the deck lifted, press the click off button
to release the brush/ pad holder then clean
and inspect before next use.
Daily: Charge the batteries: Connect
the battery charger cable to the electrical
socket. Light turns red when charging and
green when the charging is complete.
Weekly: Inspect the solution lter and
clean if required.