Vision Fitness R2600HRT User manual

Assembly
Guide
R2600HRT
COMMERCIAL FITNESS BIKE

1
STEP
2
STEP
4
STEP
To avoid possible damage to this Fitness Bike, please follow these assembly steps in the correct order. Before proceeding, find your
new Fitness Bike’s serial number located on the front axle tube, and enter here:
Refer to this number when calling for service, and enter this serial number on your Warranty Card and in your own records. Be
sure to read your Owner’s Guide before using your new Fitness Bike.
If any parts, hardware or tools are missing, please call 1.800.335.4348, Extension 12
NOTE: It is recommended that you apply grease to the threads of each screw as you assemble your Fitness Bike to prevent loosen-
ing and noise. Also, during each assembly step, ensure that ALL screws are in place and partially threaded in before completely
tightening any ONE screw.
Assembly
Guide
R2600HRT
COMMERCIAL FITNESS BIKE
5
STEP
3
STEP

TOOLS & PARTS INCLUDED
5MM Allen Wrench
Screwdriver
5MM L-Shaped Wrench
4MM L-Shaped Wrench
PARTS BOX
Console Mast Cover, Qty: 1
Water Bottle & Cage, Qty: 1
Heart Rate Chest Strap, Qty: 1
Color-coded Hardware Bags
Owner’s Guide, Qty: 1
Assembly Guide, Qty: 1
Warranty Card, Qty: 1
6MM Allen Wrench

HARDWARE INCLUDED
ORANGE BAG GREEN BAG
PINK BAG
BLUE BAG
M8 x 15L Screw
Quantity: 7
M8 x 20L Screw
Quantity: 2
M8x65L Screw
Quantity: 2
M8 Lock Washer
Quantity: 4
M8 Lock Washer
Quantity: 6
M8 x 20L Screw
Quantity: 2
M8 Lock Washer
Quantity: 4
BLACK BAG
M6 x 55L Screw
Quantity: 8
M6 Lock Washer
Quantity: 8
M8 x 15L Screw
Quantity: 4
M8 Lock Washer
Quantity: 8
M8 x 20L Screw
Quantity: 4

5
2
STEP
• Slide the rubber boot onto the
console mast.
• Unfold the wire harness and heart
rate wires located in the console mast
frame bracket. Attach the wire tie
coming from the bottom of the console
mast to the wire harness and heart
rate wires. Pull the wire tie with wire
harness and heart rate wires up
through the top of the console mast
while simultaneously sliding the mast
into the frame bracket.
• Secure the console mast to the
frame bracket with six lock washers
(M8) and six screws (M8x15L).
Tighten with the 5MM Allen wrench.
Place the seventh screw (M8x15L) in
the rear of the frame bracket and
tighten until snug.
• Slide the console mast boot down
and snap it into place on the side
cover.
• Remove the screws (M8x15L)
located half way up the console mast
with the Phillips screwdriver. Attach
the water bottle bracket to the console
mast with these two screws. Insert the
water bottle.
BLUE BAG
1
STEP
• Install the rear foot with the four lock
washers (M8), two inside screws
(M8x65L), and two outside screws
(M8x20L). Tighten with the 5MM Allen
wrench.
ORANGE BAG
1
STEP
2
STEP