VISIONARY DESIGNS MOD-1431 Manual

© 2023
Order #XXXXX
Top View
Header
Graphic
Shelf in resting
position on
L-Brackets
A10 Clips
Completed Assembly
Steps:
1) Attach base plate to charging station body, using bolts.
2) Slide shelf over top of charging station body and on top of L-brackets,
then secure, using black bolts. See Shelf Attachment detail.
3) Attach header graphic to A10 clamps on top of charging station body.
Underside of Shelf
Black
Bolt
Place Shelf on top of L-Brackets.
Secure using thumbscrews.
Shelf Attachment
*
*
Base
Plate
Bolts
Shelf
Charging
Station
Body
MOD-1431 Charging Kiosk
If you would like to tell us about your experience with your setup instructions please email us at [email protected]
SETUP INSTRUCTIONS

© 2023
Order #XXXXX
DO NOT USE POWER TOOLS
ALL CONNECTIONS MUST
BE TIGHTLY SECURED
Part Identification - Numbering
Spline Connection Base Plate & Extrusion Connection
General Setup Instructions
- Read entire setup instruction manual prior to
unpacking parts and pieces.
- The setup instructions are created specifically
for this configuration.
- Setup instructions are laid out sequentially in
steps, including exploded views with detailed
explanation for assembly.
WARNING
Cleaning & Packing
- For Cleaning Metal, Plex, & Laminate Parts:
Use a MILD NON-ABRASIVE cleanser and
soft cloth/paper towel to clean all surfaces.
- Keep exhibit components away from heat
and prolonged sun exposure.
Heat and UV exposure will warp and
fade components.
- Retain all provided Packing Materials.
All provided packing materials are for
ease of repacking & component protection.
Disassembly
- For loss prevention, tighten all set screws
and locks during disassembly.
7A
Hex Tool - Essential for Assembly
Extrusion & Lock Connection Engaged Lock
LADDERS OR LIFTS
MAY BE REQUIRED
General Information