Visonic MCS-720 User manual

D-301427 1
MCS-720
Fully Wireless Indoor Siren
Installation Instructions
1. INTRODUCTION
The MCS-720 is a fully supervised wireless siren, for indoor use, that
communicates with PowerMax Pro or PowerMaxComplete alarm system.
Features
•The siren is activated according to specific commands that are
transmitted from the alarm system (refer to the alarm system
specifications - SIREN SIGNALS).
Note: The siren is activated for a predefined "Bell Time" (refer to
PowerMax Pro / PowerMaxComplete installer guide, par. 4.4),
according to local authorities requirements, or until the system is
disarmed, whichever occurs first.
•Squawk indications when using a keyfob
High, mid or low siren squawk (beep) sound can be used to
indicate arming (1 squawk) and disarming (2 squawks) of the alarm
system.
•Flash lights / strobe
When an identified activation command is received from the alarm
system, the strobe light is activated every 1 second (100ms ON,
900ms OFF) for a period of 20 minutes maximum, or until the alarm
system is disarmed whichever occurs first. There is an option to
disable the lights/strobe locally by using an internal jumper.
•Tamper protection
The unit has tamper protection for wall and front cover opening
alarm.
•Low battery voltage alert
When the battery voltage is low, low battery message is sent to the
alarm system. After the low voltage message delivery, at least 2
siren alarms are possible before the siren is totally inactive.
•2-way full supervision
The siren is a fully supervised, 2-way communication device. It
includes a receiver, to receive activation commands from the alarm
system, and a transmitter, to periodically transmit its status signal
to the alarm system.
Figure 1 - MCS-720
The transmitted signal strength can be measured during the
installation (refer to PowerMax Pro / PowerMaxComplete installer
guide, paragraph 5.2 – Diagnostic Test).
•Self-test feature
The siren can be tested locally (by using the SELF TEST switch) or
remotely (from the control panel), upon batteries insertion, prior to
the actual wall installation.
MCS-720
Hard wired detector
Smoke detector
Wireless transmitter
Door or window
open/close detector
Motion detector
Remote commander
PowerMax Pro/
PowerMaxComplete
Figure 2 - Integration with the Alarm System.
2. SPECIFICATIONS
Siren Type: Piezo, 102dB min. SPL @ 1m, 1.8-3.5 kHz, sweep
frequency 7Hz.
Internal Battery: 3.6V 13Ah non-rechargeable EVE Lithium battery,
EEMB type ER34615M.
Note: Use only the above battery. Dispose of used battery according
to the manufacturer's instructions.
Battery life expectancy: 3 years (for typical use)
Operating Frequency (MHz): 315, 433.92, 868.95, or other frequency
according to the requirement in the country of use.
Receiver and Transmitter ID Type: 24-bit
Flash Lights Duration: 100ms ON, 900ms OFF
Dimensions (LxWxD): 161x161x50mm (6-7/16 x 6-7/16 x 1-3/4 in)
Weight (with battery):470g (16.5 oz.)
Color: white
Operating Temperature: -10°C to 60°C (-14°F to 140°F)
Compliance with Standards: EN 50131-1 Grade 2 Class II, Swedish
SSF 1014:3, Belgium TO14A.
The MCS-720 is compatible with the RTTE requirements - Directive
1999/5/EC of the European Parliament and of the Council of 9 March 1999.
3. INSTALLATION, TESTING AND ENROLLING
3.1 Installation
1
2
3
(*)
4
For back
tamper screw
5
Figure 3 - Installation

2 D-301427
3.2 Battery Pack Insertion
Note: Battery replacement should be done by a service man.
BATTERY
PACK
CONNECTOR
TURN & PUSH
BATTERY
BATTERY
BATTERY CABLE BATTERY CONNECTOR
STROBE ON-OFF JUMPER
SELF TEST SWITCH
Figure 4 - Battery Pack Insertion
3.3 Self Test
Upon pressing the self test switch more than 3 seconds (see Fig. 4),
the siren performs a functionality check during which low level piezo
sounds and flash lights indicate that the siren is fully operational.
3.4 Enrolling
The PowerMax Pro / PowerMaxComplete alarm system must
recognize the siren's unique identification code for command delivery
and supervision. To enroll the siren into the alarm system memory,
refer to the ENROLLING section of the control panel installation
instructions, and momentarily press the self-test switch (see figure 4)
when you are instructed.
After the enrolling, close the siren's cover and perform diagnostic test, as
described in PowerMax Pro / PowerMaxComplete installer guide,
DIAGNOSTIC section. Enrolling cancellation, if required, is also
described in the control panel Installer Guide, ENROLLING section.
Note
To remove the siren or to replace
its battery, without activating the
siren, login the alarm system
Installer Mode and delete the siren
from the alarm system control panel
memory, before siren removal or
siren battery replacement.
3.5 Strobe Light
Enabling / Disabling
Enable or disable the strobe
(flash) light by using the STROBE
ON-OFF jumper (see figure 4).
3.6 Cover Closure
See figure 5.
1
2
Figure 5 - Cover Closure
Interference Prevention
This device complies with FCC Rules Part 15. Operation is subject
to two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference that
may be received or that may cause undesired operation.
The digital circuit of this device has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in residential installations. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio and television reception.
However, there is no guarantee that interference will not occur in a
particular installation. If this device does cause such interference,
which can be verified by turning the device off and on, the user is
encouraged to eliminate the interference by one or more of the
following measures:
– Re-orient or re-locate the receiving antenna.
– Increase the distance between the device and the receiver.
– Connect the device to an outlet on a circuit different from the one
which supplies power to the receiver.
– Consult the dealer or an experienced radio/TV technician.
Changes or modifications not expressly approved by Visonic Ltd.
could void the user's authority to operate the equipment.
WARRANTY
Visonic Limited (the “Manufacturer") warrants this product only (the "Product") to the original
purchaser only (the “Purchaser”) against defective workmanship and materials under normal
use of the Product for a period of twelve (12) months from the date of shipment by the
Manufacturer.
This Warranty is absolutely conditional upon the Product having been properly installed,
maintained and operated under conditions of normal use in accordance with the
Manufacturers recommended installation and operation instructions. Products which have
become defective for any other reason, according to the Manufacturers discretion, such as
improper installation, failure to follow recommended installation and operational instructions,
neglect, willful damage, misuse or vandalism, accidental damage, alteration or tampering, or
repair by anyone other than the manufacturer, are not covered by this Warranty.
The Manufacturer does not represent that this Product may not be compromised and/or
circumvented or that the Product will prevent any death and/or personal injury and/or
damage to property resulting from burglary, robbery, fire or otherwise, or that the Product will
in all cases provide adequate warning or protection. The Product, properly installed and
maintained, only reduces the risk of such events without warning and it is not a guarantee or
insurance that such events will not occur.
THIS WARRANTY IS EXCLUSIVE AND EXPRESSLY IN LIEU OF ALL OTHER WARRANTIES,
OBLIGATIONS OR LIABILITIES, WHETHER WRITTEN, ORAL, EXPRESS OR IMPLIED,
INCLUDING ANY WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE, OR OTHERWISE. IN NO CASE SHALL THE MANUFACTURER BE LIABLE TO
ANYONE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES FOR BREACH OF THIS
WARRANTY OR ANY OTHER WARRANTIES WHATSOEVER, AS AFORESAID.
THE MANUFACTURER SHALL IN NO EVENT BE LIABLE FOR ANY SPECIAL, INDIRECT,
INCIDENTAL, CONSEQUENTIAL OR PUNITIVE DAMAGES OR FOR LOSS, DAMAGE, OR
EXPENSE, INCLUDING LOSS OF USE, PROFITS, REVENUE, OR GOODWILL, DIRECTLY OR
INDIRECTLY ARISING FROM PURCHASER’S USE OR INABILITY TO USE THE PRODUCT, OR
FOR LOSS OR DESTRUCTION OF OTHER PROPERTY OR FROM ANY OTHER CAUSE, EVEN IF
MANUFACTURER HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
THE MANUFACTURER SHALL HAVE NO LIABILITY FOR ANY DEATH, PERSONAL AND/OR
BODILY INJURY AND/OR DAMAGE TO PROPERTY OR OTHER LOSS WHETHER DIRECT,
INDIRECT, INCIDENTAL, CONSEQUENTIAL OR OTHERWISE, BASED ON A CLAIM THAT THE
PRODUCT FAILED TO FUNCTION.
However, if the Manufacturer is held liable, whether directly or indirectly, for any loss or
damage arising under this limited warranty, the Manufacturer's maximum liability (if any)
shall not in any case exceed the purchase price of the Product, which shall be fixed as
liquidated damages and not as a penalty, and shall be the complete and exclusive remedy
against the Manufacturer.
When accepting the delivery of the Product, the Purchaser agrees to the said conditions of
sale and warranty and he recognizes having been informed of.
Some jurisdictions do not allow the exclusion or limitation of incidental or consequential
damages, so these limitations may not apply under certain circumstances.
The Manufacturer shall be under no liability whatsoever arising out of the corruption and/or
malfunctioning of any telecommunication or electronic equipment or any programs.
The Manufacturers obligations under this Warranty are limited solely to repair and/or replace
at the Manufacturer’s discretion any Product or part thereof that may prove defective. Any
repair and/or replacement shall not extend the original Warranty period. The Manufacturer
shall not be responsible for dismantling and/or reinstallation costs. To exercise this Warranty
the Product must be returned to the Manufacturer freight pre-paid and insured. All freight
and insurance costs are the responsibility of the Purchaser and are not included in this
Warranty.
This warranty shall not be modified, varied or extended, and the Manufacturer does not
authorize any person to act on its behalf in the modification, variation or extension of this
warranty. This warranty shall apply to the Product only. All products, accessories or
attachments of others used in conjunction with the Product, including batteries, shall be
covered solely by their own warranty, if any. The Manufacturer shall not be liable for any
damage or loss whatsoever, whether directly, indirectly, incidentally, consequentially or
otherwise, caused by the malfunction of the Product due to products, accessories, or
attachments of others, including batteries, used in conjunction with the Products. This
Warranty is exclusive to the original Purchaser and is not assignable.
This Warranty is in addition to and does not affect your legal rights. Any provision in this
warranty which is contrary to the Law in the state or country were the Product is supplied
shall not apply.
Warning: The user must follow the Manufacturer’s installation and operational instructions
including testing the Product and its whole system at least once a week and to take all
necessary precautions for his/her safety and the protection of his/her property. 1/08
W.E.E.E. Product Recycling Declaration
For information regarding the recycling of this product you must contact the company from which you orignially purchased it. If you are discarding this product and not
returning it for repair then you must ensure that it is returned as identified by your supplier. This product is not to be thrown away with everyday waste.
Directive 2002/96/EC Waste Electrical and Electronic Equipment.
VISONIC LTD. (ISRAEL): P.O.B 22020 TEL-AVIV 61220 ISRAEL. PHONE: [phone], FAX: [phone]
VISONIC INC. (U.S.A.): 65 WEST DUDLEY TOWN ROAD, BLOOMFIELD CT. 06002-1376. PHONE: [phone] FAX: [phone]
VISONIC LTD. (UK): FRASER ROAD, PRIORY BUSINESS PARK, BEDFORD MK44 3WH. PHONE: [phone] FAX: [phone]
INTERNET: www.visonic.com
©VISONIC LTD. 2008 MCS-720, D-301427 (Rev. 1, 10/08)