Vivo MOUNT-VP02B User manual

Extending Projector Ceiling Mount
Scan the QR code with your mobile device or follow the link
for helpful videos and specications related to this product.
Instruction Manual
https://vivo-us.com/products/mount-vp02b
SKU: MOUNT-VP02B/W
[email protected]om www.vivo-us.com 309-278-5303
Chat live with an agent!
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST

2
PACKAGE CONTENTS
WARNING!
A (x1)
Arm
B(x1)
Bracket
M-A (x4)
M3x8mm Screw
If you do not understand these directions, or if you have any doubts about the safety of the installation,
please call a qualied technician. Check carefully to make sure there are no missing or defective parts.
Improper installation may cause damage or serious injury. Do not use this product for any purpose that is
not explicitly specied in this manual. Do not exceed weight capacity. We cannot be liable for damage or
injury caused by improper mounting, incorrect assembly or inappropriate use.
NOTE: SOME HARDWARE INCLUDED MAY NOT BE USED
M-B (x4)
M4x10mm Screw
C (x1)
Mounting Bracket
M-C (x4)
M5x10mm Screw
M-D (x4)
M6x10mm Screw
M-F (x4)
M4 OD-10
Washer
M-G (x4)
M5 OD-12
Washer
M-H (x4)
M6 OD-12 Washer
S-A (x6)
M5x12mm
Screw
S-B (x6)
M5 OD-10
Washer
T-A (x1)
4mm Allen Wrench
W-A (x4)
Screw
W-B (x4)
Anchor
W-C (x4)
M6 OD-16
Washer
CAUTION!
DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR CEILING CONSTRUCTION. USE WOOD STUDS
TO MOUNT. We include mounting for brick and concrete. If unsure, please contact us at vivo-us.com,
email at [email protected]om, or call us at 309-278-5303.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
S-C (x6)
M5 OD-10
Plastic Washer
S-D(x2)
Spacer
S-E (x2)
Plate
M-E (x4)
M3 OD-10
Washer
WASHER SPECIFICATION KEY
MCompatible Screw Size
Outside DiameterOD

3
ASSEMBLY STEPS
STEP 1
TOOLS NEEDED
Phillips
Screwdriver
Drill
OPTION A:
Run cables through Arm (A).
OPTION B:
If running cables through ceiling, pull cables through top plate of Arm (A).
30lbs
(13.61kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
A
A

4
STEP 2
OPTION A: Wood Ceiling Joist Installation
Use top plate of Arm (A) to mark mounting holes on ceiling. Using a 3/16” drill bit, drill approximately
2.2” into ceiling stud. Put Arm (A) in place and mount to the pre-drilled holes using Screws (W-A) and
M6 OD-16 Washers (W-C) as shown in diagram.
W-A
W-C
X
123

5
STEP 2 (Continued)
OPTION B: Concrete/Brick Mounting
Use top plate of Arm (A) to mark mounting holes on ceiling. Using a ⅜” drill bit, drill approximately
2.4” into ceiling. Use Anchors (W-B), Screws (W-A), and M6 OD-16 Washers (W-C) to mount Arm (A) as
shown in diagram.
2
1
W-B
W-C
W-A

6
STEP 3
Mount Bracket (B) to Arm (A) using Spacers (S-D), Plates (S-E), M5x12mm Screws (S-A), and Washers
(S-B, S-C). Tighten using 4mm Allen Wrench (T-A).
T-A
S-A S-C
S-B
S-E
S-D
B
A

7
Align arms on Mounting Bracket (C) with mounting holes in projector, and secure to
projector using Screws (M-A through M-D) and Washers (M-E through M-H) most
appropriate for your projector. If your projector has 3 mounting holes, simply remove one
of the arms.
B
C
M-A, M-B, M-C, M-D
M-E, M-F, M-G, M-H
M-A, M-B, M-C, M-D
M-E, M-F, M-G, M-H
M-A, M-B, M-C, M-D
M-E, M-F, M-G, M-H
C
C
STEP 4

8
STEP 4 Cont.

9
STEP 5
STEP 6
Adjust height and tilt of mount using the allen wrench (T-A).
+15°
-15°
-15°
+15°
Adjustment #1: Use for pitched ceiling applications ONLY.
Adjustment #2 & #3: Adjust tilt angle using one or both of these adjustments.
#1
#2
#3
Secure Mounting Bracket (C) using M5x12mm Screws (S-A), M5 OD-10 Washers (S-B) and
M5 OD-10 Plastic Washers (S-C). Tighten with 4mm Allen Wrench (T-A).
T-A
S-AS-A S-CS-C
S-BS-B
CC
T-AT-A

10
[PAGE INTENTIONALLY LEFT BLANK]