Vivo MOUNT-VP08B User manual

Extending Ceiling Projector Tray Mount
Scan the QR code with your mobile device or follow the link
for helpful videos and specications related to this product.
Instruction Manual
https://vivo-us.com/products/mount-vp08b
SKU: MOUNT-VP08B/W
[email protected]om www.vivo-us.com 309-278-5303
Chat live with an agent!
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST

2
PACKAGE CONTENTS
WARNING!
A (x1)
Mount
B (x1)
Tray
S-A (x2)
Plastic Spacer
If you do not understand these directions, or if you have any doubts about the safety of the installation,
please call a qualied technician. Check carefully to make sure there are no missing or defective parts.
Improper installation may cause damage or serious injury. Do not use this product for any purpose that is
not explicitly specied in this manual. Do not exceed weight capacity. We cannot be liable for damage or
injury caused by improper mounting, incorrect assembly or inappropriate use.
NOTE: SOME HARDWARE INCLUDED MAY NOT BE USED
TOOLS NEEDED
Phillips
Screwdriver
Drill Pencil
S-B (x2)
Threaded Plate
S-C (x4)
M5x12mm
Screw
W-A (x4)
ST6X55mm
Screw
M-C (x4)
M6 Washer
11lbs
(5kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
CAUTION!
DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR CEILING CONSTRUCTION. USE WOOD STUDS
TO MOUNT. We include mounting for brick and concrete. If unsure, please contact us at vivo-us.com,
email at [email protected]om, or call us at 309-278-5303.
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
T-A (x1)
4mm Allen
Wrench
W-B (x4)
Concrete Spacer

3
ASSEMBLY STEPS
STEP 1
OPTION A:
Run cables through arm (A).
OPTION B:
If running cables through ceiling, pull cables through top plate of arm (A).
A
A

4
STEP 2
OPTION A: Drywall Mounting
Use top plate of Mount (A) to mark mounting holes on ceiling. Using a 3/16” drill bit, drill
approximately 2.2” into ceiling stud. Put Mount (A) in place and mount to the pre-drilled holes using
ST6x55 Screws (W-A) and M6 Washers (W-C) as shown below.
1
3
2
A
W-A
W-C

5
STEP 2 (Continued)
OPTION B: Concrete/Brick Mounting
Use top plate of Mount (A) to mark mounting holes on ceiling. Using a ⅜” drill bit, drill approximately
2.4” into ceiling. Use Concrete Anchors (W-B), ST6x55mm Screws (W-A), and M6 Washers (W-C) to
mount Mount (A) as shown below.
1
3
2
W-A
W-C
W-B

6
STEP 3
Use two upper set of holes on the bottom of Mount (A) to install two M5x12mm Screws (S-C),
Plastic Spacer (S-A), and Threaded Plate (S-B) using 4mm Allen Wrench (T-A), leaving a 4mm
screw gap.
Latch Shelf (B) onto previous installed screws and install remaining M5x12mm Screws (S-C) in
remaining set of holes. Secure all screws with 4mm Allen Wrench )T-A).
T-A S-C
S-B
S-A
S-C
S-B
S-A
S-C
T-A B

7
To adjust height, use 4mm Allen Wrench (T-A) to loosen set screw in back of mount. Adjust height
and re-tighten to secure.
Place projector on assembly and connect power with previous installed cables.
STEP 4
T-A

LAST UPDATED: 10/18/2022
REV1
FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
Open Monday - Friday 7:00am - 7:00pm CST,
our dedicated support team can oer immediate assistance with rapid response times. If any
parts are received damaged or defective, please contact us. We are happy to replace parts to
ensure you have a fully functioning product.
[email protected] AVG. RESPONSE TIME (within oice hrs): 1HR 8M
- 23% within < 15m
- 38% within < 30m
- 61% within < 1hr
- 83% within < 2hr
- 92% within < 3hr
AVG. RESOLUTION TIME (within oice hrs): < 15 M
www.vivo-us.com
Chat live with an agent!
AVG. RESOLUTION TIME (within oice hrs): 5M 4S
309-278-5303