Vivo MOUNT-VW01M User manual

TV and Computer Wall Mount
Scan the QR code with your mobile device or follow the link
for helpful videos and specications related to this product.
Instruction Manual
https://vivo-us.com/products/mount-vw01m
[email protected]om www.vivo-us.com 1-800-371-5654
SKU: MOUNT-VW01M

2 3
PACKAGE CONTENTS
TOOLS NEEDED
44lbs
(19.96kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
WARNING!
Phillips
Screwdriver
B(x1)
VESA Plate
C(x2)
M6 Nut
W-A (x3)
Screw
M-A (x4)
M4x14
M-B (x4)
M5x14
M-C (x4)
D5 Washer
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualied technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specied in this manual. Do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
NOTE: NOT ALL HARDWARE INCLUDED WILL BE USED
W-C (x3)
Washer
W-B (x3)
Anchor
Drill
CAUTION!
DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR WALL CONSTRUCTION. USE WOOD STUDS TO
MOUNT. We include mounting for brick and concrete walls. If unsure, please contact us at vivo-us.
com, email at [email protected], or call us at 1-800-371-5654.
D(x1)
Cable Clip
E(x1)
Allen Wrench
F (x1)
Wrench
A (x1)
Mount
ASSEMBLY STEPS
STEP 1
OPTION A: Wood Wall
Use mount (A) to mark mounting holes on wall where stud is located. Using a 3/16” bit, drill
approximately 2.2” into marked locations. Secure mount (A) to wall using bolts (W-A) and washers
(W-C).
OPTION B: Concrete/Brick Wall
Use mount (A) to mark mounting holes on wall. Using a 3/8” bit, drill approximately 2.4” into marked
locations. Secure mount (A) to wall using anchors (W-B) bolts (W-A) and washers (W-C).

4 5
STEP 2
Attach plastic cover to mount (A).
STEP 4
STEP 3
Attach cable management clip (D) as shown in diagram.
Mount VESA plate (B) to back of TV using bolts (M-A, M-B) and washers (M-C).
STEP 5
Attach TV to mount (A) using nuts (C) as shown in diagram.

6 7
STEP 6
Adjust mount (A) using allen wrench (E) and wrench (F).
Adjust as Desired
Run cables through cable management clip (D).
STEP 7

Last Updated: 10/01/2018
If any parts are received damaged or defective, please contact us. We are happy to
replace parts to ensure you have a fully functioning product.
For more VIVO products, check out our website at:
www.vivo-us.com.
Love your new VIVO setup and want to share?
Tag us in your photo! @vivo_us
[email protected]om www.vivo-us.com 1-800-371-5654