2 3
PACKAGE CONTENTS
17.5lbs
(8kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury. 35lbs
(15.8kg)
WARNING!
A (x1)
Under
Mattress Tube
B(x1)
Clamp Brace
C(x2 )
Angled
Support
If you do not understand these directions, or if you have any doubts about the safety of the installation,
please call a qualified technician. Check carefully to make sure there are no missing or defective parts.
Improper installation may cause damage or serious injury. Do not use this product for any purpose that is
not explicitly specified in this manual. Do not exceed weight capacity. We cannot be liable for damage or
injury caused by improper mounting, incorrect assembly or inappropriate use.
Press in the spring pins on Angled Supports (C)
and slide the tubes into Clamp Brace (B) at desired
height. Ensure both Angled Supports (C) are
positioned at the same height on Clamp Brace (B)
before use.
D(x1)
Shelf
S-B (x2)
M6x18mm
Binding Barrel
S-A (x2)
M6x12mm Screw
T-A (x2)
4mm Allen
Wrench
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
STEP 1
ASSEMBLY STEPS
Slide Angled Supports (C) into Under Mattress Tube (A) so the holes on both components are aligned.
Secure using M6x12mm Screws (S-A) on inner holes, M6x18mm Binding Barrels (S-B) on outer holes,
and 4mm Allen Wrench (T-A).
Loosen the clamps on underside of Shelf (D). Slide and position Shelf (D) over the square tubing on
Clamp Brace (B) and secure by tightening underside clamps.
STEP 2
STEP 3
C
B
Mattress Thickness:
6-10”
Mattress Thickness:
10” & Above
D
B
T-A S-B
S-A
C
