Vivo MOUNT-VW11 User manual

TOOLS REQUIRED NOT INCLUDED
WARNING STATEMENTS
Warning
Safety measures must be practiced at all times during the
installation of this product. Use proper safety gear and tools
for the installation procedure to prevent personal injury.
Prior to the installation of this product, the installation
instructions should be read and completely understood.
The installation instructions must be read to prevent
personal injury and property damage. Keep these
installation instructions in an easily accessible location for
future reference.
A secure structure must support the weight or load of the
display, When mounting to a wall that contains wooden
studs, dead center of the wooden stud must be confirmed
prior to installation.
Do not install on a structure that is prone to vibration,
movement or chance of impact. Failure to do so could
result in damage to the display and/or damage to the
mounting surface.
Do not install near heater, fireplace, direct sunlight, air
conditioning or any other source of direct heat energy.
Failure to do so may result in damage to the display and
could increase the risk of fire.
At least two qualified people should perform the
installation procedure. Injury and/or damage can result
from dropping or mishandling the display.
Recommended mounting surfaces: wooden studs and
solid-flat concrete. If the mount is to be installed on any
surface other than wooden studs, use suitable hardware
(which is commercially available).
The wall structure must be capable of supporting at least a
maximum weight of 45kg (99lbs) for 32”-70” televisions.
Proper installation procedure by a qualified service
technician, as outlined in the installation instructions, must
be
result in serious personal injury and property damage.
adhered to. Failure to properly mount this product may
32" - 70"(81-178cm)
A
C D E
F
B
a
b
c
d
e
f
g
h
i
j
Φ18x6.5x1.5(x4)
M6x12 (x4)
M8x16 (x4)
M4x12 (x4)
M5x12 (x4)
M8x60 (x6)
Φ10x50 (x6)
Φ20x8x1(x6)
TOOLS REQUIRED NOT INCLUDED
?
x1pcs
M6x25(x2)
M5x12(x3)
Φ12x6.5x1.5(x4) M6(x4)
M6x35(x2)
x4pc
S=4mm xPCS
S=2.5mm xPCS
Max. VESA 600X400
For Help Please Contact Us:
Email: [email protected]
Live Chat: www.vivo-us.com
Phone: [phone]
TV 45kg/99lbs
DVD 13.6kg/30lbs
MOUNTING INSTRUCTIONS
Model: MOUNT-VW11

INSTALLATION
14 5
6
7
8
40mm
1.6”
±10°
f
Tighten the knob
Tighten the screw
3mm
30mm(1.2”)
(0.12”)
2
3
10mm
60mm(2.4”)
(0.39”)
f
g
h
X
TVTV TV TV
Option
a~d
e
i
h
i
i
j
Wood stud mounting
Mark locations on wall for drilling. Use of a stud finder is highly
recommended. Drill 1.2" deep holes with a 3mm or 1/8" drill bit, and
anchor TV mounting plate (A) to wall using screws and washers (f).
Concrete mounting
Mark locations on wall for drilling. Drill 2.4" deep holes using 10mm or
13/32" drill bit. Press anchors (g) into wall, and anchor TV mounting
plate (A) to wall using screws and washers (f).
Assemble shelf mounting bracket
(D) to hangers (C) at desired height
using nuts and washers (h). Screw
plastic thumbscrews (h) through
back of shelf mounting bracket.
Assemble shelf support (F) and L
bracket (i) to shelf mounting
bracket with screws (i). Screw
plastic thumbscrews partially into
tops of hangers.
Slip shelf support pads (j) onto shelf
support, and secure with 2.5mm Allen
key. Rest glass shelf (E) on shelf
support with pads, and secure with
screw (i). DO NOT OVERTIGHTEN,
as this could damage the glass.
Hang shelf assembly onto TV mounting plate, and secure with
previously installed thumbscrews. Turn lower thumbscrews to
adjust the angle of the shelf.
Assemble VESA brackets (B) to TV using appropriate mounting
screws (a, b, c, d) and washers (e). Ensure that VESA brackets
are positioned with slots on top and holes on bottom, and with
the tilt adjustment knobs facing away from each other.
Hang TV on TV mounting plate and secure with
installed screws underneath VESA brackets.