2 3
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualified technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specified in this manual and do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly, or
inappropriate use.
PACKAGE CONTENTS
TOOLS NEEDED
Scissors
33 lbs
(14.97kg)
DO NOT EXCEED WEIGHT CAPACITY.
Failure to do so may result in serious injury.
ASSEMBLY STEPS
STEP 4
STEP 6
Apply cable clips (D) to underside of desk.
WARNING!
Phillips
Screwdriver
A (x1)
Desk
B(x1)
Keyboard Tray
C(x4)
Sleeve Nut with
Screw
D (x2)
Cable Clip
E (x3)
Foam Pad
STEP 1
Separate parts (C) into (C1) and (C2).
STEP 5
Press foot pads (F) into holes in base. Cut the
large plastic tie beneath desk (A). CAUTION: Do
not squeeze the release handle with the dek in a
sideways or upside-down position.
Place keyboard tray (B) on metal
brackets on desk (A). Secure keyboard
tray to brackets using screws (C2) and a
Phillips screwdriver.
CAUTION!
Raise desktop slowly
to keep items stable.
Keep monitor and
laptop base fully on
the desktop.
Leave enough slack
in cable to allow for
full range of vertical
motion (15” / 38 cm).
Follow the cable
routing instructions to
avoid the potential to
pinch cables.
Failure to follow these instructions may result in property damage and/or personal
F (x4)
Foot Pad
CC1 C2
STEP 3
A
F
STEP 7
If installing a grommet compatible monitor mount, remove the plastic cap from the rear-center of the
desktop. Install the mount to the open hole according to the mount’s directions.
C2
D
1
2
3
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
Place the desk right-side up on a table. Raise the
desk by squeezing the handle underneath the
desktop.
C1 C2
STEP 2
C1
B
E
Press (C1) into holes on top
of keyboard tray (B). Apply
pads (E) to underside of
keyboard tray.
4.4lbs
(2kg)
Keyboard TrayDesk
