2 3
ASSEMBLY STEPS
STEP 1
Use screwdriver to release the latch and
separate the wall mount (A) from the
support bracket.
WARNING!
If you do not understand these directions, or if you have any doubts about the safety of the
installation, please call a qualied technician. Check carefully to make sure there are no missing or
defective parts. Improper installation may cause damage or serious injury. Do not use this product
for any purpose that is not explicitly specied in this manual. Do not exceed weight capacity.
We cannot be liable for damage or injury caused by improper mounting, incorrect assembly or
inappropriate use.
PACKAGE CONTENTS
A (x1)
Mount
B(x1)
Bolt
W-A (x3)
Screw
W-B (x3)
Anchor
C (x2)
Push
D(x2)
PIn
WARNING: CHOKING HAZARD
SMALL PARTS - NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.
CAUTION!
DO NOT INSTALL INTO DRYWALL ALONE. VERIFY YOUR WALL CONSTRUCTION. USE WOOD STUDS TO
MOUNT. We include mounting for brick and concrete walls. If unsure, please contact us at vivo-us.
A
STEP 2
Using the wall mount (A) as a template, mark drilling locations on wall with a pencil. Use of a level is
recommended.
OPTION A: Wood Wall Installation
For wood stud installation, drill 2” (50mm) deep holes using a 3/32” (2.5mm) drill bit and secure wall
mount (A) using screws (W-A).
W-A
W-B
TOOLS NEEDED
Phillips
Screwdriver
Drill Pencil
OPTION B: Concrete/Brick Wall Installation
For concrete/brick installation, drill 2.2”
(55mm) deep holes using a 5/16” (8mm) drill
bit and secure wall mount (A) using screws
(W-A) and anchors (W-B).
STEP 3
Attach support bracket to Sonos PLAY 3 speaker
using bolt (B) and push pin system (C + D).
D
C
B
STEP 4
Slide the support bracket with speaker onto
the wall mount (A) until it clicks into place.
1
2
STEP 5
Adjust tilt and swivel as desired.
±45°
0°
-18°
STEP 6
Adjust rotation as desired.
±180°
