Vivo STAND-V001R User manual

Monito Des Mount
Instruction Manual
Email: [email protected]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
-Model STAND V001R
Tools Requied
phillips screwdriver
Pacage Contents
1
Scan the QR code with your mobile device or follow the link
to helpful videos and specifications related to this product.
- -https// i o us.com/poducts/stand 001
A (x1)
Arm
B (x1)
Stopper
C (x1)
Washer
D (x1)
Base
E (x1)
M4x12
F (x1)
Pad
G (x3)
M8x10
H (x1)
5mm Alle Key
-M C (x4)
D5
-M A (x4)
M4x12
- M B (x4)
M5x12

Step 2
Assemble arm (A) to base (D) with bolts (G) using provided Allen Key
(H). Peel backing from pad (F) and stick in place over screws.
Assembl* Steps
2
Step 1
Attach stopper (B) to top of arm (A) using bolt (E) and washer (C).
Tighten using mm Allen Key (H).

Step 4
Adjust arm tension by turning screw with Allen Key (H). Clockwise
reduces tension, counter-clockwise increases tension. The tension
should be just enough to hold your monitor in place without lifting
itself up. If needed, adjust the bolts on the sides of the hinge behind
the VESA plate to tighten or loosen the tilt angle.
Step 5
Remove cable cover by removing the screw underneath using Allen
Key (H).
Step 3
Install screws (M-A) or (M-B) (use washers (M-C) if necessary) in top
two holes of the monitor, leaving 3mm of space between the screw
heads and the monitor.
Hang monitor over the top two slots in the VESA plate, install two
bottom screws, then tighten top screws.
3

If you do not understand these directions, or if you have any
doubts about the safety of the installation, please call a
qualified technician. Check carefully to make sure there are no
missing or defective parts. Improper installation may cause
damage or serious injury. Do not use this product for any
purpose that is not explicitly specified in this manual. We
cannot be liable for damage or injury caused by incorrect
assembly or inappropriate use.
Email: [e-mail]
Live chat: www.vivo-us.com
Call: 1-800-371- 6 4
For more VIVO products, check out our
website at
www.vivo-us.com.
If any parts are received damaged or defective, please contact
us. We are happy to replace parts to ensure you have a fully
functioning product.
Safet* Waning
Contact us at
Last updated: 0 /21/18
Step 6
Adjust as Desied
Insert cables, and replace cover while making sure the cables have
enough slack to allow free movement of the arm.
4