3
ASSEMBLY STEPS
STEP 1
Assemble the le foot (E) to the base (D)
using M6x10mm bolts (L), and tighten with
the 4mm Allen wrench (M). Insert the pole
(G) into the base, making sure the slot is
facing towards the back. Secure the pole
with the M10x25mm bolt (J) and 6mm
Allen wrench (M), and tighten the rear set
screw using the 4mm Allen wrench (M).
STEP 2
Slide the arm (F) onto the pole (G), loosening the thumbscrew first if needed, then place the cover (I) on top of the
pole. OPTION A: Laptop Tray Remove the bolt and white plastic spacer from the laptop hinge (B) using the 5mm
Allen wrench (M). Insert the hinge swivel joint into the top of the arm (F), making sure the tabs in the black plastic
bushing fit into the slots in the hole. Secure using the previously removed spacer and bolt with the 5mm Allen wrench
(M). Slide the laptop tray (A) into the hinge until the latch engages. Adjust the tilt joint if necessary using the 5mm
Allen wrench (M), then pull out on the sides of the tray and place the laptop computer into the tray.
OPTION B: Tablet Holder Remove the bolt and white plastic spacer from the tablet hinge (C) using the 5mm Allen
wrench (M). Insert the hinge swivel joint into the top of the arm (F), making sure the tabs in the black plastic bushing
fit into the slots in the hole. Secure using the previously removed spacer and bolt with the 5mm Allen wrench. Install
the tablet holder (H) using the M5x16mm bolt (K) with the 4mm Allen wrench (M). Adjust the tilt joint if necessary
using the 4mm Allen wrench (M), then pull out on the holder clips and place the tablet into the holder.
