VLX 2180SR User manual

2180SR Micro Rider Scrubber Quick Guide
This Guide is intended for quick consultation only and does not replace the Use and Maintenance Operator Manual.
Read the Use and Maintenance Operator Manual completely and understand the machine before operating.
Operator video available online at VLXclean.com. For technical support, call 800-861-7352.
PREPARATION & OPERATION
1. Fill the solution tank.
Measuring cup
if needed
2. Switch the machine on by turning the
ignition key.
3. Press the AUTO or ECO button; in
both modes, all the machine’s functions
will be activated. In ECO mode, the
machine consumes less energy and
operates more silently.
4. Select the direction of travel.
5. Adjust the machine’s speed using the
+ and - buttons.
6. Press the accelerator pedal.
7. Dry sweep before cleaning.
8. Begin cleaning.
When you have nished cleaning,
proceed as follows:
• Press the AUTO or ECO button to
switch off the machine’s functions.
• Turn the ignition key off.
• Recharge the batteries.
DAILY MAINTENANCE
9. Empty the dirty water tank through the
drain hose.
1
0,500 Lt
0,400 Lt
0,250 Lt
0,100 Lt
APC
APC
APC
1
©Tennant Company. Specications subject to change without notice.
2180SR Wall Chart 10/18

10. Clean the dirty water tank.
11. Check that the suction lter is
undamaged and clean.
12. Check that the detergent outlet lter
is undamaged and clean.
13. Remove and clean the brushes.
14. Check that the squeegee is clean and
the blades are not damaged.
REPLACING THE SQUEEGEE BLADES
• Open the clip (Ref. 1).
• Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting
them.
• Remove the blade.
• Reuse the same blade by reversing the edge in contact with the oor until all four
edges are worn out, or replace with a new blade, tting it onto the pins on the body
of the squeegee.
• Reposition the two blade retainers by centering the widest part of the slots over the
xing pins on the squeegee body, then pushing the blade retainers inwards.
• Fasten the clip.
• Put the squeegee back on its support, following the instructions described previously.
ATTACHING/REMOVING THE BRUSHES
Position the brush underneath the head, in the center (single-brush oor scrubber), turn the machine on.
Pressing the ATTACH/RELEASE button once after starting the machine releases the brush; pressing the button a second time
activates automatic brush attachment. The button is only enabled when all the functions are deactivated (suction motor and brush).
IF THE MACHINE IS NOT USED FOR AN EXTENDED PERIOD, UNPLUG THE EMERGENCY CONNECTOR
TO AVOID DISCHARGING THE BATTERIES.
FOR TECHNICAL SUPPORT CALL 800-861-7352
2
1
2
1
2
©Tennant Company. Specications subject to change without notice.
2180SR Wall Chart 10/18