Volt ShadowMaster VPL-1039 Series User manual

VOLT®Low Voltage Landscape Lighting
VOLT®LED ShadowMaster™ Path and Area Light
VPL-1039-Axx
INSTALLATION INSTRUCTIONS
Specications and product details subject to change without notice.
© Copyright 2016, VOLT® Lighting, Lutz FL USA 33549 • All rights re-
served. [email protected] • 813.978.3700
- 1 -

VOLT® ShadowMaster™ Path & Area light
VPL-1039-Axx
Important: Please Read Before Installation
Important Safety Instructions
INSTALLATION INSTRUCTIONS
LIGHTED LAMP IS HOT!
WARNING – TO REDUCE THE RISK OF FIRE OR INJURY TO PERSONS.
1. Turn off/unplug and allow to cool before reducing lamp.
2. Lamp gets HOT quickly!
3. Do not touch the hot lens, guard or cowl.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time.
6. Use a soft cloth.
7. Oil from skin may damage lamp.
8. Do not operate the xture with a damaged or missing lens or shield.
!
!
www.voltlighting.com [email protected] • 813.978.3700
Package Contents
A. (1) Fixture Body
B. (1) Stem
Product Dimensions
34.5”
11”
- 2 - - 3 -
C. (1) XL Hammer Stake
D. (1) LED Puck Light ( Pre-installed)
This luminaire is intended for installation in accordance with local codes and the
National Electric Code (NEC). Failure to adhere to these codes and instructions
may result in serious injury, property damage and void the warranty.
These instructions do not intend to cover all variations in installation, operation
maintenance or mounting situation.
1. Make sure that the power is turned OFF before installing or servicing this
luminaire.
2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M) or
more from pool, spa or fountain.
3. This luminaire is intended to be used only with a power supply (trans-
former) rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Wiring connections must be made with wire connectors that is suitable for
outdoor use.
5. Position the low voltage wire and wire connector so that it is located
within 6 inches (15.2 cm) from a building structure, a luminaire or tting.
6. The main low voltage cable is intended for shallow burial - less than 6
inches (152 mm)
7. If additional lengths of low voltage cable is required, please contact
www.voltlighting.com or call 1-813-978-3700.

INSTALLATION INSTRUCTIONS
[email protected] • 813.978.3700
www.voltlighting.com
- 4 - - 5 -
Install Stake
1
Board
Stake
Soil
Ground
Install Fixture to Stake
2
Pigtail
Wireway Slot
Lock Nut
Fixture
Wire Connections
3
Pigtail
Main Supply Cable
Grease Filled
Wire Connectors
VOLT® ShadowMaster™ Path & Area light
VPL-1039-Axx
Determine your desired location for
mounting the xture. Hammer the
stake into the ground until ange
of stake is ush to grade. To avoid
damage to stake, place a board on
top of the stake while hammering.
NOTE: If the ground is hard and the
stake is difcult to install, make a
crosscut in the ground using a at
shovel.
Clear away the area on the
ground at the wireway slot in the
top of the stake. Lay luminaire
pigtail into wireway slots and
thread the xture into the stake.
Tighten until snug. Thread the
lock nut at the bottom end of the
xture against the stake and hand
tighten until snug.
Strip both leads from the luminaire pigtail. Using two wire
connectors (Sold Seperately), connect leads from the luminaire
to the main supply cable leads.

- 6 - - 7 -

VPL-1039-ver1.pdf
Specications and product details subject to change without notice.
© Copyright 2016, VOLT® Lighting, Lutz FL USA 33549 • All rights re-
served. [email protected] • 813.978.3700
www.voltlighting.com
- 8 -
Help Hotline:
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)