Volt VPL-1024 User manual

VOLT®Low Voltage Landscape Lighting
VOLT® Belladonna Path & Area Light
VPL-1024
INSTALLATION INSTRUCTIONS
Specications and product details subject to change without notice.
© Copyright 2017, VOLT® Lighting, Lutz FL USA 33549 • All rights reserved.
[email protected] • 813.978.3700
Help Hotline:
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)
- 1 -

- 2 -

[email protected] • 813.978.3700
VOLT®Belladonna Path & Area Light
VPL-1024
INSTALLATION INSTRUCTIONS
- 3 -
Important: Please Read Before Installation
IMPORTANT SAFETY INSTRUCTIONS
This luminaire is intended for installation in accordance with local codes
and the National Electric Code (NEC). Failure to adhere to these codes and
instructions may result in serious injury, property damage and void the
warranty.
These instructions do not intend to cover all variations in installation,
operation maintenance or mounting situation.
1. Make sure that the power is turned OFF before installing or servicing this
luminaire.
2. WARNING: risk of electrical shock. Install all luminaires 10 feet (3.05M) or
more from pool, spa or fountain.
3. This luminaire is intended to be used only with a power supply
(transformer) rated maximum of 300 watts (25 AMPS) at 15 volts.
4. Wiring connections must be made with wire connectors that are suitable
for outdoor use.
5. Position the low voltage wire and wire connector so that it is located
within 6 inches (15.2 cm) from a building structure, a luminaire or tting.
6. The main low voltage cable is intended for shallow burial - less than 6
inches (152 mm).
7. If additional lengths of low voltage cable are required, please contact
www.voltlighting.com or call 1-813-978-3700.
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY TO PERSONS
Lighted lamp is HOT!
WARNING – To reduce the risk of FIRE OR INJURY TO PERSONS.
1. Turn o/unplug and allow to cool before replacing lamp.
2. Lamp gets HOT quickly! Contact only switch/plug when turning on.
3. Do not touch the hot lens, guard or enclosure.
4. Keep lamp away from materials that may burn.
5. Do not touch lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.
6. Do not operate the luminaire tting with a missing or damaged shield.
SAVE THESE INSTRUCTIONS
!
!

Package Contents
Product Dimensions
A. (1) Fixture Body
B. (1) Stake
11.5”
8”
3.5”
26.5”
C. (1) Diuser
Parts Required
A. (1) LED Lamp
Install Stake
1
Board
Stake
Soil
Ground
- 4 -
www.voltlighting.com
Determine the desired location for mounting
the luminaire. Hammer the stake into the
ground until ange of stake is ush to grade.
To avoid damage to the stake, place a board on
top of the stake while hammering.
NOTE: If the ground is hard and the stake
is dicult to install, make a crosscut in the
ground using a at shovel.

INSTALLATION INSTRUCTIONS
[email protected] • 813.978.3700
VOLT®Belladonna Path & Area Light
VPL-1024
Install Fixture Body to Stake
2
Wire Connection
3
Fixture Body
Stake
Pigtail
Wireway Slot
Strip both leads from the luminaire pigtail. Using two wire connectors
(sold separately), connect the leads from the luminaire to the main
supply cable leads.
Pigtail
Main Supply Cable
Wire Connectors
- 5 -
Clear away an area in the ground at
the wireway slot on top of the stake.
Lay the luminaire pigtail into the
wireway slot and thread the coupler
at the bottom end of the xture body
onto the stake. Tighten until snug to
secure the base.

Install Lamp
Install Diuser
4
5
Insert the bulb with the correct wattage
and type marked on the xture label.
CAUTION: Do not exceed maximum
wattage marked on luminaire label.
NOTE: DO NOT touch bulb with bare
hands. Use soft cloth to handle bulb.
Remove the screws from the
shade. Attach the diuser onto
the shade and secure with the
screws previously removed.
Socket
Shade
Bulb
Diuser
Screw
Install/Replace Bulb
Please reverse Step 5 - Step 4 to expose the Bulb and replace it with the
correct wattage and type marked on the xture label. Reinstall Diuser.
IMPORTANT: LED Bulb must be protected from moisture and dust at all
times. Always reinstall diuser when moved.
- 6 -
www.voltlighting.com

[email protected] • 813.978.3700
- 7 -

- 8 -
Specications and product details subject to change without notice.
© Copyright 2017, VOLT® Lighting, Lutz FL USA 33549 • All rights
reserved. [email protected] • 813.978.3700
www.voltlighting.com
IS-VPL-1024-ver2.pdf
Help Hotline:
1-813-978-3700 • Mon-Fri 8am-8pm • Sat-Sun 10am - 6pm (EST)