
power supply is possible. The device then switches automatically to the 230
volt operation (the batteries are then switched o). Plug the mains adapter
into the socket.
The connection cable has a length of ve meters. The mains adapter is
splash proof and is suitable for outdoor use. If you wish to switch from
battery to mains mode during use of the VOSS.sonic 360, simply plug the
power adapter into the unit and the battery is disconnected. If you want to
switch back to battery operation, remove the mains plug. This will discharge
the batteries.
Place the appliance where you want to deter animals. The all-round protec-
tion from the VOSS.sonic 360 oers you for the rst time the possibility to
completely protect your car by placing the device under the car in the midd-
le. You can also put it on the ground and then drive over it You should have
a height of at least 12cm from the ground to the vehicle. If you are using the
VOSS.sonic 360 using a mains adapter, you should not drive over the cables.
It is possible to operate the VOSS.sonic 360 mounted from the ceiling. For
this purpose, holes with 4.5 mm Ø are available in the 3 stands. This variant
is only permissible in roofed rooms if it is ensured that no water (for example,
condensation water) drips onto the unit.
The VOSS.sonic 360 can be used in all areas and will protect a space of up to
700 m², depending on local conditions. Ensure that no external land is used
without the consent of the owner.
The unit is now ready for operation.
Use:
Use the magnet to turn on the unit at the designated point (Figure 1) and
set it to the desired level. Three circularly arranged infrared motion sensors
detect the approaching animals in the range of 360 degrees. The ultrasound
signals are emitted all around , in circular movements, by 3 loudspeakers.
The dierent ultrasound signals are usually not audible for people, only
those who are really sensitive and have a good hearing will notice a low
noise. For animals, however, it is so unpleasant that they leave the audible
area. If animals do not react immediately, it is because they still have to
understand that this area is unpleasant for them. If the infrared sensor
detects no further movements, the device switches to the power saving /
standby mode.
After a power failure (In 230-volt operation), the device must be started
again with the magnet.