VTech Baby Pop & Play Activity Tree User manual

Pop & Play Activity Tree
Instruction Manual

C
M
Y
CM
MY
CY
CMY
K
Grow with VTech(101x127)bw1P-V2.pdf 1 08/18/2014 9:29:01

3
INTRODUCTION
Introducing the Pop & Play Activity Tree by VTech®.
Discover numbers, colours and more with this interactive discovery
tree! Drop the multicoloured balls into the tree to hear them be
counted aloud! Features a spiral track with random ball routes, so
you’ll never know where the balls will go!
OFF/Low/High
Volume Switch
Pop Up
Bear
5 Light Up Buttons
Koala
Door
Recognition
Point
SeesawGears
Bee
Pendulum

4
INCLUDED IN THE PACKAGE
• One Pop & Play Activity Tree
• One Quick Start Guide
• Four balls
WARNING:
All packing materials such as tape, plastic sheets, packaging locks,
removable tags, cable ties, cords and packaging screws are not part
of this toy and should be discarded for your child’s safety.
NOTE:
Please save this Instruction Manual as it contains important information.
GETTING STARTED
BATTERY REMOVAL AND INSTALLATION
1. Make sure the unit is turned OFF.
2. Locate the battery cover located on
the bottom of the unit, Use a coin or a
screwdriver to loosen the screw and
then open the battery cover.
3. If used batteries are present, remove
these batteries from the unit by pulling
up on one end of each battery.
Removing the Packaging Locks:
Rotate the packaging locks 90 degrees
anticlockwise.
Pull out the packaging locks and discard.

5
4. Install 2 new AA (AM-3/LR6) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended).
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
IMPORTANT: BATTERY INFORMATION
• Insert batteries with the correct polarity (+ and -).
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable batteries.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Do not short-circuit the supply terminals.
• Remove batteries during long periods of non-use.
• Remove exhausted batteries from the toy.
• Disposeofbatteriessafely.Donotdisposeofbatteriesinre.
RECHARGEABLE BATTERIES
• Remove rechargeable batteries (if removable) from toy before
charging.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not charge non-rechargeable batteries.

6
Disposal of batteries and product
The crossed-out wheelie bin symbols on products and
batteries, or on their respective packaging, indicates they
must not be disposed of in domestic waste as they contain
substances that can be damaging to the environment and
human health.
The chemical symbols Hg, Cd or Pb, where marked,
indicatethatthebatterycontainsmorethanthespecied
value of mercury (Hg), cadmium (Cd) or lead (Pb) set out in
the Batteries and Accumulators Regulation.
The solid bar indicates that the product was placed on the
market after 13th August, 2005.
Please dispose of your product and batteries responsibly.
In the UK, give this toy a second life by disposing of it at a small
electricals collection point* so all of its materials can be recycled.
Learn more at:
www.vtech.co.uk/recycle
www.vtech.com.au/sustainability
* Visit www.recyclenow.com to see a list of collection points near you.

7
PRODUCT FEATURES
1. Off/Low/High Volume Switch
To turn the unit On, slide the Off/Low/
High Volume Switch to the Low or
High position. You will hear a playful
song, a phrase and sounds. To turn
the unit Off, slide the Off/Low/High
Volume Switch to the Off position.
2. Automatic Shut Off
To preserve battery life, the Pop & Play Activity Tree will
automatically shut off after approximately 30 seconds without
input. The unit can be turned on again by pressing the light up
buttons or by inserting the ball into the tree top.
NOTE
If the unit powers down whilst playing, please install a brand new set
of batteries.
WARNING: Do not aim at eyes or face.
ACTIVITIES
1. PresstheveLightUpButtonsto
hear songs, phrases, sounds and
melodies.Thelightwillashwiththe
sounds.
2. Drop the balls into the tree and it will
count them aloud.

8
3. Press the seesaw to pop the ball up
onto the purple track for looping play
and to hear fun sounds.
4. Touch the bee pendulum to hear fun
sounds.
5. Pull the koala to release a ball to see
it roll down.
6. Spin the gears for added fun!
SING-ALONG SONG LYRICS
Song 1
Red, yellow, purple and blue!
Drop the balls in the top of the tree!
Watch them slide, watch them roll,
Which direction will they go?

9
Song 2
Look around the playful trees, what animals do you see?
A honey bee buzzing in the tree!
A bear playing peek-a-boo!
Song 3
1, 2, 3, 4, and 5,
Drop in a ball and count with me,
6, 7, 8, 9 and 10,
Let's count the balls together!
Song 4
Colourfulbutterylikestoutterfromowertoower.
Song 5
Ladybird all red and black, crawls along the bright green grass.
Song 6
Nibble, nibble, crunch, crunch. Yum, yum, yum!
Caterpillar snacks on big green leaves.
Song 7
Busy buzzy honeybee, sipping nectar to make some honey.
Song 8
Snail moves slowly, snail is never in a hurry.
MELODY LIST
1. Row, Row, Row Your Boat
2. Flying Trapeze
3. Girls and Boys Come Out to Play
4. Hey Diddle Diddle
5. Looby Loo
6. One Man Went to Mow a Meadow
7. Skip to My Lou
8. Toyland

10
9. Yankee Doodle
10. Wheels on the Bus
11. Teddy Bears' Picnic
12. Pat-A-Cake
13. Mulberry Bush
14. Little Bo-Peep
15. Humpty Dumpty
CARE & MAINTENANCE
1. Keep the unit clean by wiping it with a slightly damp cloth.
2. Keep the unit out of direct sunlight and away from any direct heat
sources.
3. Remove the batteries if the unit will not be in use for an extended
period of time.
4. Do not drop the unit on hard surfaces and do not expose the unit
to moisture or water.
TROUBLESHOOTING
If for some reason the unit stops working or malfunctions, please
follow these steps:
1. Turn the unit Off.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for a few minutes, then replace the batteries.
4. Turn the unit On. The unit should now be ready to use again.
5. If the unit still does not work, install a new set of batteries.
If the problem persists, please contact our Consumer Services
Department and a service representative will be happy to help you.