Wahl V7000 SALON Series User manual

CONSUMER TOOL CARE
Cleaning your Wahl clippers blades
EVERYDAY CLEANING
Your tools should be cleaned
after every time you use them.
Start by brushing off excess hair
on your blades.
Make sure you oil your blades
after cleaning them with Wahl
Blade Oil.

CONSUMER TOOL CARE
Cleaning your Wahl clippers blades
ONCE A MONTH CLEANING
Your Clipper blades should be
removed periodically (at least
once a month) to allow the cut
hair to be cleaned out from under
the blades.
Simply use a screwdriver to undo
the blade screws and then
remove the blades. Remove the
sponge and clean it plus any hair
that is caught in the clipper.
Reverse the process to re-attach
the blades.
All Wahl Clippers
are tested before they
leave our factory. Often
testing materials or grinding
compound may be found on the
blades. This is easily cleaned
off using the enclosed blade
cleaning brush.

CONSUMER TOOL CARE
Oiling your Wahl clippers blades
With the blade directed down-
wards, turn the clipper/trimmer
on.
Apply three drops of oil – one on
each side and one in the middle.
With the clipper/trimmer still on,
move the taper lever back and
forth to work oil into blade.
Turn off clipper/trimmer and blot
excess oil with clean towel.
Always use Wahl Clipper Oil on your Wahl tools as it is
specifically designed to extend the life of your blades.
HOW TO OIL YOUR BLADES

CONSUMER TOOL CARE
Aligning your Wahl clippers blades
HOW TO ALIGN YOUR BLADES
If your clipper has a taper lever,
move the taper lever upwards
towards the lid of the clipper so
the blades are in the closed
position i.e. closest cutting length.
The top & bottom blades should
be parallel with the top blade
approximately 0.8mm behind the
bottom blade (do not have the top
blade level with the bottom blade
as this can cause skin pinching or
cutting). See Diagram Below.
The extreme left hand tooth on
the top blade should be
positioned so it is over the gap
between the two left hand teeth of
the lower blade. i.e. the extreme
left gap on the lower blade. See
Diagram Below.
Slowly tighten each screw ensur-
ing you do not alter the alignment
in the process. The best way is to
tighten each screw a little at a
time swapping from one to the
other.
Check your alignment setting with
the blades tightened and the lever
in the closed position to ensure
you do not cause pinching or
cutting of the skin.
Closed
Opened
0.8mm
Closed