Wali WL-FTM-1 User manual

Supplied Parts List
2
(4)M4x12 Bolt-h (4)M4x30 Bolt-i (4)M6x20 Bolt-j
(2)Monitor Bracket (1)Bubble Level-a
Note: The mounting components and hardware supplied in this package are
not designed for installations to walls with steel studs or to cinder block walls.
If the hardware you need for your installation is not included, please consult
your local hardware store for proper mounting hardware for the application.
Tools Required 4mm Drill Bit
Phillips Screwdriver
10mm Masonry Bit
Carpenter's Level
(4)M6 Washer-f(8)M6/M8 Spacer-d (4)M4 Washer-e
(4)M8x20 Bolt-l (4)M8x35 Bolt-m (4)M8x50 Bolt-n
(4)Lag Bolt-q(4)Lag Bolt Washer-p (4)Concrete Anchor-r
(4)M8 Washer-g
(1)Wall Plate
(4)M4 Spacer-c
(4)M6x35 Bolt-k
(4)Bolt Cover-o
(1)Allen Key-b

Step 1 Mounting the Wall Plate to the Wall
3
CAUTION!
WARNING
!This TV mount must be securely attached to the
vertical wall. If the mount is not properly
installed it may fall, resulting in possible injury
and/or damage.
65mm
4mm
Wood Studs Wall qp
Please don’t install
upside down.
Attention:
Brick or Concrete Wall
60mm
65mm
10mm
r
qp
Please don’t install
upside down.
Attention:
o
o

Step 2 Mounting the Monitor Brackets to a TV
First of all, Once you have
determined the correct diameter, please see the diagram as below. You will thread the
Bolt into the TV using the correct Washer(e,f,g), and using the spacer(c,d) if necessary.
Please make sure the Monitor Brackets are vertically centered and level with each
other.
make sure the diameter of the Bolt(h to n) your TV requires.
4
Step 3 Attaching TV to Wall Plate and Adding the Safety Bolts
Warning: Some TVs may require two people to lift! We are not responsible for
personal injury or product damage.
First hook the Monitor Brackets over the top of the Wall Plate, then let the bottom of the
Monitor Brackets rotate to the bottom of the Wall Plate as shown in the below diagram.
Use the screw driver to tighten the safety bolts. Then the Monitor Brackets will sit
behind the bottom tab on the Wall Plate as shown in the diagram.
3.1
3.2
3.3
h to n
e,f,g
c,d
(if necessary)

Step 4 Level the TV Mount
Loosen four bolts by maximum ONE 360 degree turn as below diagram, then adjust the
level of the TV, finally fasten the bolts by supplied Allen Key(b).
WARNING: Don’t over loose the bolts to provent the TV from falling off!
5
Step 5 Adjusting the Tilting Angle
Adjust the TV to the desired angle and fasten the two bolts by the supplier Allen Key(b)
as below diagram.
WARNING: Don’t over loose the bolts to provent the TV from falling off!
b
b