Ware Manufacturing Chick-N-Hutch User manual

6 - Washers
PARTS DESCRIPTION:
Chick-N-Hutch •Assembly Instructions
Tools Required: Regular Screwdriver
1-800-295-2243
625 S. 27th Avenue
Suite 120
Phoenix, AZ 85009
www.waremfginc.com Revised 02/10/09
STEP 2
1 of 2
STEP 1
Install Pan Rails
on the Left "B"
and Right "B"
sides using
8- 2" Bolts
Fasten Side Panels (B) to Front Panel (C).
Use 6- 2" Bolts and 6- Wing Nuts.
Make Sure Door Faces Outward on Left Side
and that the Hutch Slants to the Back.
All wire must face
into the cage
17 - Wing Nuts
10 - ¾”Bolts
8 - 1 ½”Bolts
14 - 2”Bolts
2" Bolts

STEP 5
STEP 4
STEP 3
Set Roof on Top of Hutch.
Align Hinges and Attach 4- 3/4" Bolts.
Install “Stop Chain” as Shown Below
using 1- 3/4" Bolt.
ITEM #01490 MADE IN CHINA
to the exact Design Specications of
WARE MFG.INC
Phoenix, AZ, USA 85004
VISIT US AT
www.waremfg.com
Slide Floor into Bottom of Hutch, Wire
Side Up. Align Side Holes and Fasten
Back Panel (D) to Side Panels using
6- 1 1/2" Bolts and 6- Wing Nuts.
FLOOR
Wing Nuts should face into the Hutch.
Tip: This item (as any wood) should be periodically (every 12 to 18 months
depending on climate) treated with a non-toxic exterior grade stain.
Slide Pan in Front Below Floor on Pan
Rails. Attach Wind Guards to Outside
Side Panels Using 4- 3/4" Bolts,
4- Washers and 4- Wing Nuts.
Attach Chick-N-Roost Using
2- 1 1/2" Bolts and 2- Washers
3/4" Bolt 3/4" Bolt
Attach Egg Door with
1- 3/4" Bolt and 1- Wing Nut