Ware Manufacturing HD Chick-N-Rabbit Pen User manual

Item #01491
Align and Attach Side Panel (B) hinges to
Front Panel (A) by using 8- 1" Bolts.
Step 1
Step 3
Attach
Floor Brace
to the front
of Pen using
1- 1½" Wood
Screw on each
Side Panel.
Floor Brace in Front
Step 2
Hutch
HD Chick-N-Rabbit Pen
Assembly
Instructions
4 - 1½" Wood Screws
16 - 2” Bolts
8 - 1” Bolts
4 - L Brackets
8 - ½" Wood Screws
#30001491
D - Back PanelC - Top PanelB - Side Panels (x2) Floor Braces (x2)A - Front Panel
PARTS DESCRIPTION:
All wire must face into the cage
Unfold Top Panel (C). Align
Holes with Side Panels (B)
and Front Panel (A). Secure
Panels together using
14-
2" Bolts.
Note: small section
goes towards the
back of Pen.
small section

Attach Back Panel (D) to the bottom
of the Chick-N-Hutch, Large Rabbit Hutch or
Townhouse Hutch.
Secure with
2- 2" Bolts
2"
Bolt
If your new pet home experienced damage during shipping, DO NOT RETURN TO THE STORE.
Contact our customer service department at 1-800-295-2243 and we will help you with any problems,
Mon-Fri 8:00 – 4:00 MST or through our website at www.waremfginc.com
Line up the left and
right sides of the HD
Chick-N-Rabbit Pen
to Hutch. Remove
wingnut from the
upper front side of
Hutch and attach "L"
shaped bracket using
the same wingnut.
Secure bracket with
2- ½" Wood Screws.
Repeat step for lower
front side bracket.
Perform on opposite
side of Hutch also.
Assembly is now
complete for your
HD Chick-N-Rabbit
Pen.
lower
front side
bracket
upper
front side
bracket
Tip: This item
(as any wood)
should be peri-
odically (every
12 to 18 months
depending on
climate) treated
with a non-toxic
exterior grade
stain.
ITEM #01491
The HD
Chick-N-Rabbit
Pen can be used
with the
•HD Chick-N-Hutch
(Item #01490)
•HD Large Rabbit Hutch
(Item #01550)
•HD Townhouse Hutch
(Item #01509)
Insert a
1½" Wood
Screw
above the
door frame.
Step 4
Step 6
Step 5
MADE IN CHINA
to the design specifications of
WARE MFG., INC.
Phoenix, AZ 85009, USA
WWW.WAREMFGINC.COM