WAREMA PB Parts list manual

WAREMA Pleated blind with handle
Type PB/PK
Instructions for installation, use and
maintenance
To be handed over to the operator.
Please keep for future use.
Valid from 22 March 2016
Document number 2007645 [Rev. 2 - en]

Table of contents
Page 2 | 12 2007645 [Rev. 2 - en]/2016-03-22
Table of contents
1 Introduction....................................................................................................................... 3
1.1 Information on safety.................................................................................................................................... 3
1.2 Information on the target group and application of these instructions......................................................... 3
1.3 Basic safety instructions............................................................................................................................... 3
2 Installation PB...................................................................................................................4
2.1 Rabbet installation........................................................................................................................................ 4
2.2 Angle bracket installation..............................................................................................................................5
3 Installation PK...................................................................................................................7
3.1 Rabbet installation........................................................................................................................................ 7
3.2 Angle bracket installation..............................................................................................................................8
4 Operation with handle.................................................................................................... 10
5 Maintenance....................................................................................................................10
5.1 Cleaning...................................................................................................................................................... 10
5.2 Warranty......................................................................................................................................................10
5.3 Spare parts/repairs..................................................................................................................................... 11

Introduction
2007645 [Rev. 2 - en]/2016-03-22 Page 3 | 12
1 Introduction
1.1 Information on safety
It is important to follow these instructions in the interests of
personal safety. Failure to comply with these instructions
when operating the product may result in personal injury
and/or property damage. Failure to comply with these
instructions relieves WAREMA of liability.
Warnings are marked in the instructions with this
symbol or a similar symbol.
Read through the product instructions carefully
before installation and use.
Read and follow all safety, setting, operating and
maintenance instructions.
Include these instructions if you pass the product
on to a new owner.
Keep the instructions until you dispose of the
product.
1.2 Information on the target group and
application of these instructions
Target group
These instructions are directed at people who install,
operate, care for and/or maintain the product.
Knowledge of occupational safety, accident prevention
regulations, working with ladders and scaffolding,
attachment of fixing materials, assessment of the building
fabric, and commissioning and operation of the product is
required for installing the product.
If any of these qualifications are unavailable, the work must
be carried out by a specialist fitting company.
Contents
These instructions are an integral part of the following
product: Pleated blind with handle Type PB/PK
These instructions contain important information on the
handling, installation, commissioning, operation, care
and maintenance of this item. Other versions or special
solutions are not dealt with.
Permissible activities
Performing tasks on the product that are not described in
these instructions is not permissible. No other alterations,
additions, conversions or maintenance work is to be
carried out on the product other than as described in these
instructions without the written approval of WAREMA.
1.3 Basic safety instructions
The safety instructions and warnings described here
are intended to safeguard your health and to protect the
product. These instructions must be read carefully and
followed.
Damage resulting from inappropriate use or the failure to
follow these instructions is not covered by the warranty.
Liability will not be accepted for secondary damage.
Installation preparations
Improper installation may impair the safety, function and
service life of the product. This may result in injury to
persons and/or cause damage to the product and adjacent
parts.
If the skills necessary for installing the product are
not available, have the product installed by a qualified
specialist
Comply with the sequence and the specified installation
steps.
Install the product only if it is in technically perfect
condition.
General operation
The operation of a faulty product may injure persons and/or
damage adjacent parts.
Only operate the product if it is in technically perfect
condition.
If the product makes unusual noises or movements,
stop using it immediately and inform a qualified
specialist.

Installation PB
Page 4 | 12 2007645 [Rev. 2 - en]/2016-03-22
2 Installation PB
2.1 Rabbet installation
Measuring and drilling the fixing points
112
35 35
35 35
112
112
112
112
Installing the pleated blind
1
2
3
Click!
4
Click!
5
6
7
1
2
8

Installation PB
2007645 [Rev. 2 - en]/2016-03-22 Page 5 | 12
Dismantling
1
2
2.2 Angle bracket installation
Measuring and drilling the fixing points
= x - 2
= x
100
Installing the pleated blind
1
2
3
4

Installation PB
Page 6 | 12 2007645 [Rev. 2 - en]/2016-03-22
5
6
7
Click!
8
Click!
9
10
11
1
2
12
Dismantling
1
2

Installation PK
2007645 [Rev. 2 - en]/2016-03-22 Page 7 | 12
3 Installation PK
3.1 Rabbet installation
Measuring and drilling the fixing points
35 35
35 35
112
112
112
112
112
100
100
Installing the pleated blind
1
2
3
Click!
4
Click!
5
6
7
1
2
8
9

Installation PK
Page 8 | 12 2007645 [Rev. 2 - en]/2016-03-22
Dismantling
1
2
3.2 Angle bracket installation
Measuring and drilling the fixing points
100
Installing the pleated blind
1
2
3
4
5
6
7
Click!
8
Click!

Installation PK
2007645 [Rev. 2 - en]/2016-03-22 Page 9 | 12
9
10
11
1
2
12
13
Dismantling
1
2

Operation with handle
Page 10 | 12 2007645 [Rev. 2 - en]/2016-03-22
4 Operation with handle
If necessary, slide the
rod onto the handle.
Raise and lower the
pleated blind using the
handle/rod.
5 Maintenance
Proper and regular cleaning and the use of original spare
parts only are essential for fault-free operation and a long
service life.
CAUTION
Risk of injury from falling from climbing aid!
Climbing aids may tip over if they are improperly
erected.
Position climbing aids on level and firm ground.
Do not rest climbing aids against the product.
5.1 Cleaning
To ensure the longest possible life, we recommend
that you clean the surface of the product regularly or
at least once a year.
If the first cleaning takes place several years after
initial installation, the product or fabric cannot be
restored to its original condition.
Replacement claims cannot be honoured on the
grounds of these cleaning instructions because the
effectiveness of these measures depends on a large
number of factors that vary from case to case.
Always follow the manufacturer instructions when
using chemical cleaning products. In the interest of
the environment, it is recommended that you only
use 100% biologically degradable cleaning products.
NOTICE
Product damage from incorrect cleaning!
Incorrect cleaning procedures may result in damage
to the product or product parts, and the surfaces and
structures may be permanently altered.
Do not use abrasive cleansers or sponges and
solvents such as alcohol or naphtha.
Remove dust from the surfaces using a soft
brush or feather duster.
Clean the surfaces with a suitable cleaning
agent.
5.2 Warranty
Subject to the statutory period of limitation for warranty
claims. This requires regular maintenance. The warranty
does not include wear parts or optical changes in line
with the type of material used (e.g. bleaching of surfaces
caused by UV rays).

Maintenance
2007645 [Rev. 2 - en]/2016-03-22 Page 11 | 12
5.3 Spare parts/repairs
INFO
To ensure that your product will operate properly
on a continuous basis and to avoid changing
its approved status, use original spare parts
only. Contact your WAREMA specialist dealer if
necessary.

WAREMA Renkhoff SE - Hans-Wilhelm-Renkhoff-Straße 2 - 97828 Marktheidenfeld - Germany
www.warema.com - [email protected]