WATCHMARK SMARTONE User manual

WWW.WATCHMARK.COM
USER MANUAL

4
7
8
Time, date
Pedometer
Calorie counter
Distance
Screen brightness
adjustment
Blood pressure
Saturation
ECG
Pulse
Find phone" function
Stopwatch
Timer
Alarm
Sleep monitor
Music control
Sports modes
Change of dial theme
Weather
Notifications / messages
Calls
Reset device
Settings
11
5
6
12
13
14
15
16
TABLE OF CONTENTS
Introduction
About the watch
Device configuration
Packaging content
Hardware requirements
Charging the watch
Additional information
How to wear
a smartwatch?
Belt change
Applications and functions
Installing the app 9
Smartwatch functions 10

20
21
22
App functions 17
Measurement history
Notifications
Change of dial theme
ECG
Frequent contacts
Phone camera control
Find device" function
Alarm
Movement reminder
Hydration reminder
G-Sensor
Weather
Automatic heart rate
monitoring
18
23
19
TABLE OF CONTENTS
General Information Applications and functions
Specifications
Product complaint
Product return
Product exchange

A multifunctional smartwatch created for those who enjoy an active
lifestyle. Thanks to the built-in speakers and microphone, you can
take calls straight from your wrist. You will also find 7 sports
modes, measurement of calories burned and a heart rate monitor.
The watch's menu is in English.
Device configuration
Contents of the package
4
Introduction
About Watchmark Smartone
Smartwatch (colour and
material may vary depending on
the colour chosen)
Strap (colour and material
may vary depending on the
colour chosen)
Charger (colour and material
may vary depending on the
model selected)

iOS 9.0 and above
Android 5.0 and above
Bluetooth supported: 4.0
Hardware requirements
Charging instructions
This smartwatch uses magnetic charging.
Connect the charging cable to the USB input and to the rear
charging contacts of the device. Once connected, charging will
start automatically and the charging icon will appear on the
screen.
It takes approximately 2 hours to fully charge the battery. Do not
use the watch while it is charging.
Caution: do not connect the magnetic charging cable to any
2 contacts at the same time with conductive material, as this
may cause a short circuit.
Android 5.0+ IOS 9.0+
5

6
Please read the entire user manual carefully before using the
equipment. It is recommended to use only the original battery,
charger and accessories that are included in the kit received
with the device.
Neither the manufacturer nor the distributor is responsible for
the use of third-party accessories.
The functions that are presented in this manual may vary
between models, as the manual is a general description of
smartwatches. Some models may deviate from the standard.
Before using the device for the first time, charge it for a
minimum of 2 hours. Before using the device, you must
download and install the app and accept all consents that the
smartwatch asks for. If this is not done fully, not all features of
the device will be available. The smartwatch will only ask for
access to functions that are necessary for the smartwatch to
function properly.
The company reserves the right to change the content of this
manual.
Additional information

7
How to wear a smartwatch?
The strap for this watch model is 22 mm wide. It is
interchangeable and additional straps can be purchased in
a different colour or material.
Wearing the watch
When you're not exercising, wear the smartwatch as you
would a regular watch, i.e. one finger above your wrist bone.
To take full advantage of the heart rate monitoring function
during exercise, try wearing the device above your wrist
(2 fingers above your wrist bone) to improve comfort and
stability. Many exercises, such as cycling or weightlifting, can
cause the smartwatch's placement to change by bending the
wrist, for example. If the watch sits lower on the wrist bone
measurements can be intermittent, so correct placement
is important.

8
Belt change
Insert one end of the strap together with the telescope
into the recess of the watch envelope.
With the other end, insert the telescope into the centre of
the cavity and attach it to the watch.
Attach the original strap to the watch before using it. When
carrying out this operation, take careful care and watch out
for your fingernails when attaching the telescopes to the
watch.
1.
2.
Wearing the belt
Removing the belt
With one hand, press the wheel on the telescope and
gently push inwards.
Then, pull upwards until the telescope detaches from the
watch.
1.
2.

The app for the Smartone smartwatch model is "FitCloudPro".
Download the app from the Google Play / App Store or via
the QR code below. The app is in English.
Once the app is installed, turn on Bluetooth on your phone and go
to the app. Create an account or continue without registering. Fill
in your data and allow access. For the app to work properly, you
need to give all the consents it asks for. To connect your watch,
select "Scanning" and then the watch model (Smart Watch -
85E).
To use the smartwatch to make and receive calls, connect the
watch via Bluetooth as well. On your phone, go to the Bluetooth
settings and establish a connection with the device named "BT-
85E". Without such a connection, some of the functions will not
be active.
Google Play App Store
9
Applications and functions
Installing applications

Features available on the Smartwatch
Time, date, day of the week
Pedometer
Calorie counter
Distance travelled
Adjusting the brightness of the screen backlight
The display shows the time, date and day of the week. The
data is displayed on the main screen of the watch.
Counts the steps taken on a given day (data resets each day
from 00:00). The number of steps taken can be seen in the app
or in the first tab to the right of the main screen.
Calculates the number of calories burned on a given day. The
data on calories burned can be found in the first tab to the right
of the home screen or in the app.
Information on how much distance was covered during the day.
Distance travelled can be found in the first tab to the right of the
home screen or in the app.
Adjusting the brightness helps protect your eyes from a screen
that is too bright at night and saves the watch battery. You can
find this function in the drop-down menu from the main screen.
10