Weslo WLCL99617.3 User manual

USER’S MANUAL
weslo.com
Serial
Number
Decal
Model No. WLCL99617.3
Serial No.
Write the serial number in the space
above for reference.
CAUTION
Read all precautions and
instructions in this manual before
using this equipment. Keep this
manual for future reference.
To register your product and
activate your warranty today,
go to my.weslo.com.
For service at any time, go to
wesloservice.com.
Or call 1-866-699-3756
Mon.–Fri. 6 a.m.–6 p.m. MT
Sat. 8 a.m.–12 p.m. MT
Please do not contact the store.
ACTIVATE YOUR
WARRANTY
CUSTOMER CARE

2
WARNING DECAL PLACEMENT
This drawing shows the location(s) of the warning decal(s). If a decal is missing or illegible, see the
front cover of this manual and request a free replacement decal. Apply the decal in the location
shown. Note: The decal(s) may not be shown at actual size.
WESLO is a registered trademark of ICON Health & Fitness, Inc.
WARNING DECAL PLACEMENT . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
IMPORTANT PRECAUTIONS..................................................................3
BEFORE YOU BEGIN. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
PART IDENTIFICATION CHART. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
ASSEMBLY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .7
HOW TO USE THE STEPPER CLIMBER. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
MAINTENANCE AND TROUBLESHOOTING.....................................................13
FCC INFORMATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13
EXERCISE GUIDELINES ....................................................................14
PART LIST/EXPLODED DRAWING . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15
ORDERING REPLACEMENT PARTS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Back Cover
LIMITED WARRANTY. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Back Cover
TABLE OF CONTENTS

3
IMPORTANT PRECAUTIONS
WARNING: To reduce the risk of serious injury, read all important precautions and
instructions in this manual and all warnings on your stepper climber before using your stepper
climber. ICON assumes no responsibility for personal injury or property damage sustained by or
through the use of this product.
1. It is the responsibility of the owner to ensure
that all users of the stepper climber are
adequately informed of all precautions.
2. Before beginning any exercise program,
consult your physician. This is especially
important for persons over age 35 or per-
sons with pre-existing health problems.
3. The stepper climber is not intended for use
by persons with reduced physical, sensory,
or mental capabilities or lack of experience
and knowledge, unless they are given super-
vision or instruction about use of the stepper
climber by someone responsible for their
safety.
4. Use the stepper climber only as described in
this manual.
5. The stepper climber is intended for home
use only. Do not use the stepper climber in a
commercial, rental, or institutional setting.
6. Keep the stepper climber indoors, away from
moisture and dust. Do not put the stepper
climber in a garage or covered patio, or near
water.
7. Place the stepper climber on a level surface,
with a mat beneath it to protect the floor
or carpet. Make sure that there is at least
2 ft. (0.6 m) of clearance around the stepper
climber.
8. Inspect and properly tighten all parts each
time the stepper climber is used. Replace
any worn parts immediately.
9. Keep children under age 13 and pets away
from the stepper climber at all times.
10. Wear appropriate clothes while exercising;
do not wear loose clothes that could become
caught on the stepper climber. Always wear
athletic shoes for foot protection.
11. The stepper climber should not be used
by persons weighing more than 250 lbs.
(114 kg).
12. Be careful when mounting and dismounting
the stepper climber.
13. Always keep your back straight while using
the stepper climber; do not arch your back.
14. Over exercising may result in serious injury
or death. If you feel faint, if you become short
of breath, or if you experience pain while
exercising, stop immediately and cool down.

4
STANDARD SERVICE PLANS

5
BEFORE YOU BEGIN
Handle
Handlebar
Pin
Pedal
Rear Stabilizer
Front Stabilizer
Console
Frame
Knob
Knob
Thank you for selecting the new WESLO®CLIMBER
stepper climber. Stepping is one of the most effective
exercises for increasing cardiovascular fitness, building
endurance, and toning the entire body. The CLIMBER
stepper climber provides a selection of features
designed to make your workouts at home more effec-
tive and enjoyable.
For your benefit, read this manual carefully before
you use the stepper climber. If you have questions
after reading this manual, please see the front cover
of this manual. To help us assist you, note the product
model number and serial number before contacting us.
The model number and the location of the serial num-
ber decal are shown on the front cover of this manual.
Before reading further, please review the drawing
below and familiarize yourself with the labeled parts.
Height: 6 ft. 6 in. (198 cm)
Length: 3 ft. 3 in. (100 cm)
Width: 2 ft. (61 cm)
Grip
Wheel
Handle
Grip

6
M8 Acorn Nut
(6)–4
M8 x 25mm
Screw (3)–2
M8 Washer
(7)–4
M8 x 32mm
Carriage Bolt (9)–4
M6 x 20mm
Screw (5)–4
Stop Screw
(17)–2
PART IDENTIFICATION CHART
Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. The number following the
key number is the quantity needed for assembly. Note: If a part is not in the hardware kit, check to see if it
has been preassembled. Extra parts may be included.

7
• To hire an authorized service technician to
assemble this product, call 1-800-445-2480.
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you complete all assembly steps.
• Left parts are marked “L” or “Left” and right parts
are marked “R” or “Right.”
• To identify small parts, see page 6.
• In addition to the included tool(s), assembly
requires the following tools:
one adjustable wrench
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
ASSEMBLY
1
2. Remove the Pin (13) from the Frame (14), unfold
the Stand (24) as shown, and then re-insert the
Pin into the Frame.
2
14
13
24
1. Go to my.weslo.com on your computer and
register your product.
• documents your ownership
• activates your warranty
• ensures priority customer support if assistance
is ever needed
Note: If you do not have internet access, call
Customer Care (see the front cover of this
manual) and register your product.

8
4
8
9
7
6
6
7
9
10
3. Attach the Rear Stabilizer (10) to the Frame (14)
with two M8 x 32mm Carriage Bolts (9), two M8
Washers (7), and two M8 Acorn Nuts (6).
Attach the Front Stabilizer (8) to the Stand
(24) in the same way.
3
55
4. Identify the Right Pedal (11), and attach it to the
right side of the Frame (14) with two M6 x 20mm
Screws (5).
Attach the Left Pedal (4) to the left side of the
Frame (14) in the same way.
4
14
14 11
24

9
12
17
3
15
15
A
B
5
5. Using a plastic bag to keep your fingers clean,
apply a generous amount of the included grease
to the Frame Bushings (30) in the top of the
Frame (14).
Next, identify the Right Handlebar (12). Insert
the Right Handlebar into the right side of the
Frame (14) as shown, and then attach it with an
M8 x 25mm Screw (3).
Then, tighten a Stop Screw (17) into the Right
Handlebar (12).
Attach the Left Handlebar (2) to the left side
of the Frame (14) in the same way.
14
Grease
2
30
30
14
6
6. Orient a Grip (15) as shown, press the pin (A),
and then insert the Grip into the right side of the
Frame (14); make sure that the pin is in the
indicated hole (B) in the Frame.
Attach the other Grip (15) to the left side of
the Frame (14) in the same way.

10
7
7. The Console (1) can use one AA battery (not
included); an alkaline battery is recommended.
IMPORTANT: If the Console has been
exposed to cold temperatures, allow it to
warm to room temperature before you insert
a battery. Otherwise, you may damage the
Console or other electronic components.
Remove the battery cover from the back of the
Console (1), and insert a battery into the battery
compartment. Make sure to orient the battery
as shown by the diagram inside the battery
compartment. Then, reattach the battery cover.
Next, hold the Console (1) near the Frame (14),
and connect the wire (C) on the Console to the
Reed Switch Wire (20) in the Frame (14).
Tip: Avoid pinching the wires. Slide the
Console (1) onto the clip (D) on the Frame (14).
1
C
D
20
8. Make sure that all parts are properly tightened before you use the stepper climber. After the stepper
climber is assembled, inspect it to make sure that it is assembled correctly and that it functions prop-
erly. Extra parts may be included. Place a mat under the stepper climber to protect the floor or carpet from
damage.
Avoid pinching
the wires
14