West Elm Metal and Wood Medicine Cabinet Quick start guide

Metal and Wood Medicine Cabinet
Assembly and Mounting Instructions
Hardware Included:
Parts Included:
THREE Glass Shelves TWELVE Clips ONE Medicine Cabinet
Note:
This item includes one mounting bracket that is first secured to a wall. The Cabinet is later mounted and secured to the
mounting bracket.
“WARNING! DO NOT MOUNT THIS ITEM ABOVE CRIBS, BEDS, or CHANGING TABLES”
Each shelf maximum total weight capacity for this product is 5 pounds (2.2 kg).
Mounting Instructions: (Assembly Option 1 – Surface Mounted )
1. Determine the desired placement on the wall for the cabinet. Within the desired mounting location, locate
the wall-studs using a stud finder and mark out stud locations using a pencil.
2. Hold the wall-bracket level against the wall at the desired mounting location and try to have one or two holes
of the bracket align to the wall-studs. Using a pencil, mark the wall through each of the three screw holes of
the bracket. Remove the bracket and set aside. The resulting marks on the wall are the insertion points for
the mounting hardware.
The hardware included with this item is meant for drywall or stud
mounting only. If your wall is made from another material such
as concrete or plaster, please consult your local hardware store
for assistance in selecting the correct hardware.
TOOLS NEEDED (not included):
(3) Phillips head screws (3) Anchors (4) Slatted head screws (1) Wall Bracket

Dry Wall Installation (diagram shown on the right and below)
Using a Phillips screwdriver to engage an anchor, press the anchor tip against the wall at insertion mark. Driver the anchor
into the wall (turn the clockwise while applying an even pressure on it) until its head is flush with the wall surface. Do not
over-tighten. Once all anchors are in place, place the wall-
Bracket over the anchors and insert mounting screws clockwise just until you feel resistance.
Stud Mounting (see illustration below):
If the mark aligns with a wall stud, hold the mounting bracket against the wall so that the hole of the bracket aligns. Then
use the screwdriver to install a screw through the hole and directly into the wall and stud. Rotate the screw clockwise until
the mounting bracket is firmly secured to the wall.
Once the wall-mount bracket is secured to the wall, raise the Cabinet and position the Cabinet’s bracket over the wall-
mount bracket so that the brackets engage each other. Make sure the ends of both brackets are aligned.

Mounting Instructions: (Assembly Option 2 – Recess Mounted )
1. Measure a space for the Cabinet body, blocking is recommended to ensure adequate support, Inset box
measurements will vary according cabinet box dimension.
2. Install the cabinet with recessed box set back within the wall cavity.
3. Mount cabinet by fastening the enclosed slotted head screws from inner side panels. The screws can be used for
installation into wood frame only.
Install the shelves
For each shelf, insert four U shaped clips into pre-drill holes that are provided along the inside walls of the cabinet.

Note:
After the cabinet is installed, If the door do not appear square or aligned, loosen or tighten the appropriate screws on each
case hinge as illustrated.
Care Instructions:
Wipe with a soft, dry cloth.
To protect the finish, do not use household cleaners or abrasives.
Thank you for your purchase!
Stores | Catalog | www.westelm.com