Widex Baby 440 User manual

Quick Guide

introduction
This is a quick guide for daily use and handling, and is
intended for parents, grandparents and other relevant
persons, such as supporting/nursing sta. Please refer to
the sections “Warnings” and “Good Advice”.
As this quick guide is an abridged version of the complete
user guide, ‘USER INSTRUCTIONS BB4 RITE RECEIVER-
IN-THE-EAR’, please refer to the complete user guide for
further information.
Ear-tip
Sound tube
Earwire Microphone openings
Light-emitting
diode
Hearing aid
Battery drawer
Anchor
Sound bore
Eye loop

PositioninG
the hearinG aid
Instant receIver ear-tIp
1. Make sure that the receiver housing inside the ear-tip
sits correctly.
2. Place the hearing aid behind the ear.
3. Insert the instant receiver ear-tip in the ear.
4. Check that the hearing aid and the earpiece are posi-
tioned correctly.
Same procedure for custom receiver earmould.
32 4
1a 1b

4
12
3
securinG
the hearinG aid
adhesIve tape
1. Peel o an adhesive strip from the pack.
2. Attach the strip to the hearing aid.
3. Remove the cover from the strip.
4. Position the hearing aid behind the ear, pressing lightly
to ensure the hearing aid remains in place.

1
2a 2b 3
securinG
the hearinG aid
secureFIx - retentIon strIng
1. The retention string helps ensure that the hearing aid is
kept in place.
2. Fasten the string to the hearing aid as illustrated.
3. Attach the clip to the child’s clothing and use the slider
to adjust the string.
Make sure your child is not entangled by the string.

1 2
34
insertinG
the battery
how to Insert the battery
1. Remove the tab from the battery.
2. Open the battery drawer using the opening tool.
3. Place the battery in the drawer as illustrated.
4. Close the battery drawer.

1a 1b 2
Dai ly checK
check the earpIece
1. Make sure that the earpiece is free of earwax, moisture
or the like.
check the battery
2. Check that the diode on the hearing aid flashes. If not,
the battery may be exhausted.

1a 1b
2 3
Dai ly sound checK
check the sound
1. Connect the listening tube to the hearing aid as
illustrated.
2. Close the battery drawer to turn the hearing aid on.
3. Check the sound in the hearing aid before placing it in
the child’s ear.

removinG the
hearinG aid
1. Remove the hearing aid from its position behind your
child’s ear.
2. Carefully pull the earpiece out of the ear canal, while
holding the lower part of the earwire.
2
1

1 2 3
3.
cleaninG
cleanIng the hearIng aId
1. Clean the hearing aid with the dry cloth provided.
Never use any fluids.
Leave the battery door open when the hearing aid is not
in use.
cleanIng the Instant receIver ear-tIp
2. Use the wax loop to dig out any hard earwax.
3. Insert the wax brush into the earpiece to remove any
soft earwax.
Same procedure for custom receiver earmould.