Windsor Clipper Duo User manual

OPERATION
Clipper
WINDSOR
01)
Install jets and brush.
05)
Adjust handle for push or pull
cleaning and operator height.
04) For spotting:
Hook up vacuum
line, solution line, and tool if
necessary.
02)
Fill solution tank with extraction
rinse or fresh water and replace
the lid properly. The notch on the
lid should match up with the notch
in the tank.
06) Turn on brush motor.
03)
Make sure that all three prongs
are on the main body of the cord.
iFone oF the prongs is missing, notiFy
your supervisor. Plug in to outlet and
machine cord and twist to lock.
07) Starting at the highest set-
ting, adjust brush height set-
ting by setting until you hear
the brush hit the carpet.

OPERATION
Clipper
WINDSOR
08)
Turn on the vacuum motor.
11) Unplug the cord from the
wall when nished.
09)
Choose continuous or intermit-
tent spray. Press buttons on
handle to control spray on
intermittent mode.
10) Overlap 2-3” on ever pass, and
on intermittent spray release
button and continue pulling
for 1 foot before making a
new pass.

MAINTENANCE
Clipper
WINDSOR
01) Drain recovery tank and
solution tank.
05) inspeCt brush:
When the black
brush bristles reach the height
of the yellow indicator bristles
replace the brush.
04) Clean the brush and
vacuum shoe.
02)
Rinse and clean recovery tank.
06) Store brush in the recovery
tank with the bearing side
up and vent the recovery
tank dome to let dry.
03) Clean the oat shut off.
07) Soak spray jets in a solu-
tion of water and vinegar
overnight.