Winners Only BTB User manual

Page 1 of 3
WINNERS ONLY
R
ASSEMBLY INSTRUCTIONS
Allen Bolts
Flat Washer
HB Left Leg
Slat
Support Leg
Slat
Support Leg
STEP 1: Attach the Wood Stretcher (D) to both Headboard Legs (A&B)
using provided hardware as shown on FIG.1
Caution:Pleasereadinstructionsthoroughlybeforeunpackingassemblyparts.Sharp,exposedstapletipscancauseinjury.Therefore,foryour
protection,pleaseremoveanyexposedstaplesusedinpacking.
Pleasekeepallhardwarepartsoutofthereachofchildren.
1.Werecommendthatyoushouldassemblethisproductwiththeassistanceofanotherperson;thiswillmakeassemblyeasierandwillhelpto
eliminatedamagetotheproductorinjurytopersonsduringassembly.
2.Besuretocheckallpackingmaterialscarefullyforsmallpartsthatmayhavecomelooseinsidethecartonduringshipment.
3.Pleasedonotovertightenscrewsorbolts.
4.Pleaseputallpartsonanon-abrasivefloorbeforeassembly,andfollowtheassemblystepstoassembleyournewlypurchasedproduct
correctlyandefficiently.
PROD.NO : BTG/BTH/BTP1001Q
PROD.NO : BTB/BTG/BTH/BTP1001F

WINNERS ONLYR
ASSEMBLY INSTRUCTIONS
Page 2 of 3
STEP 3: Attach both Bed Rails (F) to the Headboard
assembly (A,B,D&C) using the provided hardware as
shown on FIG.3
STEP 3: Attach both Bed Rails (F) to the Footboard (E)
using the provided hardware as shown on FIG.4
STEP 2: Attach the Headboard (C) to the Legs
assembly (A,B&D) using provided hardware as
shown on FIG.2
PROD.NO : BTG/BTH/BTP1001Q
PROD.NO : BTB/BTG/BTH/BTP1001F

Page 3 of 3
WINNERS ONLY
R
ASSEMBLY INSTRUCTIONS
STEP 5: Attach Support Legs (H) to Slats (G)as shown on FIG.5.
STEP 6: Attach Slats with Support legs (G&H) to the Side Rail
(F) using the provided hardware as shown on FIG.6
Assembly is now completed.
PROD.NO : BTB/BTG/BTH/BTP1001F
PROD.NO : BTG/BTH/BTP1001Q

WINNERS ONLY
ASSEMBLY INSTRUCTIONS
Page 1 of 1
WARNING: Before the removal or installation of charging kit disconnect charging kit from any electrical outlets.
Fig.1
STEP 2: Attach charging kit on the desired headboard leg
using 2 screws and phillips screwdriver as shown in Fig. 3.
Step 1: Using a phillips screwdriver remove the 2 screws
attaching the charging kit to headboard leg as shown in Fig.1.
BTB/BTG/BTH/BTP1001F
BTB/BTG/BTH/BTP1001T
Charging Kit Removal And Installation.
Note:
The Manufacturing label should not be visible
once charging kit is installed as shown in Fig. 2.
Fig. 3
Fig.2.
R