Winners Only DS5455 User manual

WINNERS ONLY
®
ASSEMBLY INSTRUCTIONS
PROD. NO: DS5455
Thank you for purchasing this quality product. Please read instructions thoroughly before unpacking
the assembly parts.
1 OF 2
Caution : Sharp exposed staple tips can cause injury, therefore for your protection, please remove any exposed
staples used in packing.
Please keep all hardware parts out of the reach of children.
1. We recommend that you should assemble this product with assistance of another person; this will
make the assembly easier, and will help to prevent personal injury and to insure parts are not damaged during
the assembly process.
2. Before beginning, please check the packing materials carefully for small parts which may have come
loose inside the carton during shipping. Please do not discard any packing material until all parts have been
located. If any parts are missing, please contact your dealer for prompt replacement.
3. To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for
stain residues and rough surfaces and also check for staples or nails left after removing the packing materials.
The manufacturer will not be held responsible if preventive steps are not taken prior to installation.
4. Please do not over tighten screws or bolts. During normal use everyday, screws, bolts, nuts and wooden
plugs may loosen up. They should be periodically inspected and re-tightened to prevent damage to the furniture
and (or) peronal property or cause injury. Always check to be sure all hardware on this list and the below
mentioned components are attached to the furniture properly and kept tightened.
5. Please lay all parts and hardware on a non abrasive surface such as a carpet, and follow the assembly.
This product will take 15-20
minutes to assemble
Components List:
B
QTYSKETCHDESCRIPTION
NO
ABENCH TOP
4 PCS
LEG
1 PC
MADE IN MALAYSIA

Step.2 Turn the bench to a standing position.
Step.3 Check the bench balance and tighten
all the Legs to complete the assembly.
Note: Do not over tighten the Legs to
prevent the bolts from stripping.
Step 1.1 Attach Leg (B) to Table top (A)
as shown on FIG 1.1 by turning all Legs (B)
clockwise.
Assembly is now complete.
2 OF 2
WINNERS ONLY
®
ASSEMBLY INSTRUCTIONS
PROD. NO: DS5455
FIG 1.1
A
B
Protective surface