Winners Only DRT245824 User manual

PAGE 1 OF 3 MADE IN MALAYSIA
ABR-20302-SCMWU
DRT245824
PROD . NO:
WINNERS ONLY
HARDWARE LIST:
Pan Head Screw
Glue
8pcs
Flat Washer
Allen Key
Lock Washer
JCBC Bolt
8 x 1 1/4”
10g
M6 x 70mm
M6 x 13mm
M6.5 x 16.5mm
M4 x 2.1/2”
8 pcs
8 pcs
8 pcs
1pce
1pce
1
2
3
4
5
6
This product will take 15-20
minutes to assemble.
Screw driver is require for assembly (not included)
 TIP:store the Allen key and or Wrench used in assembly
in this product’s drawer or use masking or painter’s tape
to affix it to the underside of the product .this will make it
easier to find if you want to periodically tighten bolts or
disassemble the product.
Cushion Seat
Front Leg ( Left )
Front Leg (Right )
Short Stretcher
Long Stretcher
NO
COMPONENT LIST:
SKETCH
DESCRIPTION QTY
1 pce
2 pcs
2 pcs
2 pcs
2 pcs
Hardware Bag 1pack
A
B
C
D
F
E
NO SKETCHSIZE
DESCRIPTION QTY
Thank you for purchasing this quality product. Please read the instructions thoroughly before unpacking the
assembly parts.
Caution: Sharp exposed staple tips can cause injury, therefore for your protection, please remove
any exposed staples used in packing.
Please keep all hardware parts out of the reach of children.
1.We recommend that you should assemble this product with the assistance of another person: this will make the
assembly easier,and will help to prevent personal injury and to insure parts are not damaged during the
assembly process.
2.Before beginning,please check the packing materials carefully for small parts which may have come loose
inside the carton during shipping. Please do not discard any packing material until all parts have been located.
If any parts are missing, please contact your dealer for prompt replacement.
3.To prevent damage to your floor or carpet, please check the bottom of each piece of furniture for stain residues
and rough surfaces and also check for staples or nails left after removing the packing materials. The manufacturer
will not be held responsible if preventive steps are not taken prior to installation.
4. Please do not over tighten screws or bolts. During normal use everyday,screws,bolts,nuts and wooden plugs
may loosen up. They should be periodically inspected and re-tightened to prevent damage to the furniture
and (or) personal property of cause injury. Always check to be sure all harware on this list and the below
mentioned components are attached to the furniture properly and kept tightened.
5.Please lay all parts and hardware on a non abrasive surface such as a carpet,and follow the assembly.

PAGE 2 OF 3 MADE IN MALAYSIA
ABR-20302-SCMWU
DRT245824-(B)
DRT245824-(E)
DRT245824-(D)
DRT245824-(F)
DRT245824-(C)
DRT245824
SADDLE BARSTOOL
WINNERS ONLY
ASSEMBLY :
STEP 1
1. Attach the stretcher to the leg with fully inserted into the pre-drilled holes. As shown on fig1.
C
C
6
D
D
F
F
E
E
Apply Glue
Fig.1
DRT245824-(F)

ABR-20302-SCMWU
2. Put the Cushion Seat on a soft surface such as a carpet. Place the legs to corner block of the frame, by using provided hardware.
As shown in Fig.2 
2.1.
Insert Pan Head Screw into stretcher through the pre-drilled holes, tighten with screw-driver (Not Provided).As shown in Fig.2.1.
PAGE 3 OF 3 MADE IN MALAYSIA
CARE INSTRUCTION
~ Be sure to use the same type of polish consistenly.
Your furniture will appear cloudy or streaky if oil
based or wax based polishes are interchanged.
~ Spray your furniture surface evenly. Wipe in a
circular motion with a soft clean cloth.
STEP 2
DRT245824
SADDLE BARSTOOL
WINNERS ONLY
ASSEMBLY :
3.1- Turn the Barstool to standing position.
3.2-
STEP 3
Check it's balance and tighten all screw and bolts to complete the assembly.
B
E
F
12
4
5
3
Fig 2
Fig 2.1
Assembly is now Completed.