Wolf CT30S Instructions for use

Planning Information
New 30" (762) Induction Cooktop —Available October 2007
MODEL CT30I/S
1
Dimensions in parentheses are in
millimeters unless otherwise specified.
9/07
Model CT30I/S
Induction cooking has been used in Europe for decades
byprofessionals and homeownersdemanding the best
in performance.
In induction cooking, the electricity flows through a coil
to produce a magnetic field under the ceramic cooktop.
When a cast iron or magnetic stainless steel pan is
placed on the ceramic glass surface, currents are
induced in the cooking utensil and instant heat is gener-
ated due to the resistance of the pan. Induction only
works with cooking vessels made of magnetic materi-
als, such as cast iron and magnetic stainless steel (it
will not work with aluminum or copper pots). Totest the
cookware, a magnet must stick to the bottom of the
vessel in order to function.
Induction cooking is so efficient that it out-performs gas
and electric cooktops. There is no wasted heat because
energy is supplied directly to the cooking vessel, so
nearly 90 percent of the energy gets used to cook.
You can keep sauces and chocolates melted at 50 watts
of power,or with the touch of a finger, activate the
Hi-Power boost feature and boil water in nearly half the
time you normally do.
The new induction cooktops will be available in October
2007.
The Wolf Model CT30I/S 30" (762)
induction cooktop is available with classic
stainless steel trim finish.
MELTHIGH
OFF ON
HI-POWER
HIGH
SIMOFFON
CLEAR
OFF
O
HI-POWER
HIGH
SIM OFFON
MELTHIGH
OFFON
Four induction
elements
Location of
rating plate
Classic stainless
steel trim finish
Melt setting Electronic
touch controls
Lock key
Hot-surface
indicator light
Universal
OFF key
Countdown
timer
True Simmer on
all elements
Melt setting

Planning Information
New 30" (762) Induction Cooktop
MODEL CT30I/S
2
21"
(533)
OVERALL
DEPTH
30" (762)
OVERALL WIDTH
TERMINAL BOX
31/2"(89) 41/2"(114)
OVERALL DIMENSIONS
FEATURES
Classic stainless steel trim finish
Easy-to-clean black ceramic glass surface is
resistant to scratching, staining, impact and
heat
Induction elements heat cookware, not the
glass, for a cooler, safer cooking surface
Four high-efficiency induction elements
deliver power and control
Maximum element power: (2) 1800 W with
3000 W boost and (2) 1200 W
True Simmer setting on two elements
Melt setting on two elements
Cookware sensing—elements will not be
energized without an induction-compatible
pan on the cooktop surface
Hi-Power mode boosts power on 1800 W
elements by diverting power from adjacent
element
Temperature limiter to ensure that safe
operating temperature of ceramic glass is
never exceeded
Illuminated touch controls with graduated
control lighting and adjustable sound
frequency and volume
Hot-surface indicator light in control panel
Lock mode—cooktop will be locked so that
no elements can be turned on
Universal OFF turns all elements off
Countdown timer with 1 to 99 minute range
CSA certified for US and Canada
Two and five year residential warranty—
exclusions apply; warranty information can
be found on our website,wolfappliance.com
Dimensions in parentheses are in
millimeters unless otherwise specified.
Unit dimensions may vary by ± 1/8"(3).

Planning Information
New 30" (762) Induction Cooktop
MODEL CT30I/S
Dimensions in parentheses are in
millimeters unless otherwise specified. 3
SPECIFICATIONS
Overall Cooktop Width 30" (762)
Overall Cooktop Height 3 1/2"(89)
Overall Cooktop Depth 21" (533)
Element Maximum Power (2) 1200 W
(2) 1800 W with 3000 W boost
Maximum Power Output 7200 W
Element Diameters
51/2" (140), 6 3/4" (171) and (2) 8 3/4" (220)
Recommended Cabinet Width 33" (838)
Minimum Cabinet Width 30" (762)
Minimum Cabinet Depth 22 3/4"(578)
Minimum Height Clearance* 4 1/2"(114)
Cooktop Cut-Out Width 28 3/8"(721)
Cooktop Cut-Out Depth 19 1/4"(489)
Electrical Supply Requirements 240/208 V AC
50/60 Hz, 40 amp circuit
Conduit 4 ft (1.2 m) flexible 3-wire
Electrical Rating 7.2 kW at 240 V
6.3 kW at 208 V
Shipping Weight 48 lbs (22 kg)
*Minimum 6" (152) clearance is required between countertop and
any combustible surface directly below the cooktop.
Specifications are subject to change without notice.
VENTILATION OPTIONS
30" (762) Cooktop hood or Pro
wall or wall chimney hood or liner
30" (762) or 45" (1143) downdraft
ventilation system
36" (914) Pro island hood
For additional information, refer to the
Cooktop or Pro Ventilation sections of our
website, wolfappliance.com.
ACCESSORIES
Filler strip
Accessories are available through your
Wolf dealer. To obtain local dealer
information, visit the Showroom Locator
section of our website, wolfappliance.com.
Model CT30I/S
Unit dimensions may vary by ± 1/8"(3).

Planning Information
New 30" (762) Induction Cooktop
MODEL CT30I/S
Dimensions in parentheses are in
millimeters unless otherwise specified. 4
INSTALLATION SPECIFICATIONS
2"*min (51)
CUT-OUT TO
COMBUSTIBLE
MATERIALS
(BOTH SIDES)
18"
(457)
191/4"(489)
COOKTOP CUT-OUT
DEPTH
21/2"min
(64)
36" (914)
STANDARD
FLOOR TO
COUNTERTOP
HEIGHT
13" max
(330) 30" (762)
COUNTERTOP TO
COMBUSTIBLE
MATERIALS
ABOVE COOKTOP
24"min
(610)
*Minimum clearance from both side edges of cooktop cut-out to combustible materials up to 18" (457) abovecountertop. **Minimum clearance
from rear edge of cooktop cut-out to combustible materials up to 18" (457) abovecountertop.
33/4"min
(95)
30-INCH OVEN OPENING
41/2"(114)
10"
(254)
31/2"(89) E
283/8"(721) COOKTOP
CUT-OUT WIDTH
283/8"(721)
COOKTOP CUT-OUT WIDTH
FRONT OF COUNTERTOP
21/2"min
(64)
191/4"(489)
COOKTOP
CUT-OUT DEPTH
33" (838) RECOMMENDED
CABINET WIDTH
30"min (762)
2"**
(51)
DIMENSIONS
Recommended Cabinet Width 33" (838)
Minimum Cabinet Depth 22 3/4"(578)
Cooktop Cut-Out Width 28 3/8"(721)
Cooktop Cut-Out Depth 191/4"(489)
Location of Electrical Within shaded area
See Installation Instructions shipped with unit for detailed specifications.

Planning Information
New 30" (762) Induction Cooktop
MODEL CT30I/S
Dimensions in parentheses are in
millimeters unless otherwise specified. 5
INSTALLATION NOTES
Refer to the illustrations and specifications
for overall dimensions, cut-out dimensions and
installation specifics.
Wolf recommends using 33" (838) cabinets
with the 30" (762) induction cooktop.
Clearance is required for the terminal block
located on the bottom of the cooktop in the
right rear corner.
IMPORTANT NOTE: Aminimum height clear-
ance of 6" (152) is required between the coun-
tertop and any combustible surface directly
below the cooktop. This includes upper edges
of drawers located directly below unit. If a shelf
is installed below the unit, a 1" (25) gap at the
rear of the cabinet shelf is necessary to allow
for proper ventilation. Failure to do so could
result in decreased performance or product
damage.
AWolf downdraft system, Cooktop or
Pro ventilation hood is recommended. When
installing a ventilation hood, refer to the specific
requirements of the hood for the minimum
dimension to countertop. Also refer to the
ventilation recommendation charts in the
cooktop or Proventilation sections of our
website, wolfappliance.com.
The Wolf 30" (762) induction cooktop
requires a separate, grounded 3-wire 240/208 V
AC, 50/60 Hz, 40 amp service with its own
circuit breaker. It has a 4' (1.2 m) flexible 3-wire
conduit for connection at the electrical supply.
Locate electrical within the shaded area shown
in the Installation illustration on page 4.
AWolf built-in single oven may be installed
below this cooktop. For this installation, the
electrical supply for the cooktop should be
installed in the adjacent cabinet. Refer to page 6
for specifications. Be aware of the depth of the
cooktop when planning for this installation.
IMPORTANT NOTE: When a built-in oven is
installed below the cooktop, unless you are
using cabinets deeper than 24" (610), it is
recommended that the electrical supply be
placed in an adjacent cabinet within reach of
the conduit.
IMPORTANT NOTE: Wolf induction cooktops
are designed and agency approved for installa-
tion with Wolf built-in ovens only.
You must follow all National Electrical Code
regulations. In addition, be aware of local codes
and ordinances when installing your service.
If the 30" (762) induction cooktop is to be
used with any combination of additional
cooktop units or modules with a filler strip, the
cut-out width increases to 29" (737). When
multiple cooktops or modules are installed side
by side, refer to the countertop cut-out dimen-
sions on page 7.
Refer to the installation instructions
shipped with each Wolf product for detailed
specifications.
This cooktop is intended for indoor use only.

Planning Information
New 30" (762) Induction Cooktop
MODEL CT30I/S
Dimensions in parentheses are in
millimeters unless otherwise specified. 6
INSTALLATION WITH BUILT-IN OVEN
The Wolf 30" (762) induction cooktop may be
installed above a 30" (762) L Series or E Series
built-in single oven. Refer to the illustration
below for specifications.
IMPORTANT NOTE: When a oven is installed
below the cooktop, unless you are using
cabinets deeper than 24" (610), it is recom-
mended that the electrical supply for the oven
and the electrical supply for the cooktop be
located in the adjacent right side cabinet. A 2"
(51) diameter hole to route the conduit through
cabinetry will be required.
IMPORTANT NOTE: Wolf electric cooktops are
designed and agency approved for installation
with Wolf built-in ovens only.
Wolf recommends using 33" (838) wide cabinets
for this installation. A minimum 24" (610) of
usable cabinet depth is required. The cabinet
base must be able to support 250 lbs (113 kg).
The Wolf 30" (762) induction cooktop may also
beinstalled above a Wolf 36" (914) L Series
single oven.
For electrical requirements and additional
specifications, refer to Built-In Ovens section of
our website, wolfappliance.com.
2"*min (51)
CUT-OUT TO
COMBUSTIBLE
MATERIALS
(BOTH SIDES)
18"
(457)
191/4"(489)
COOKTOP CUT-OUT
DEPTH
21/2"min
(64)
36" (914)
STANDARD
FLOOR TO
COUNTERTOP
HEIGHT
13" max
(330) 30" (762)
COUNTERTOP TO
COMBUSTIBLE
MATERIALS
ABOVE COOKTOP
*Minimum clearance from both side edges of cooktop cut-out to combustible materials up to 18" (457) abovecountertop. **Minimum clearance
from rear edge of cooktop cut-out to combustible materials up to 18" (457) abovecountertop. Unless you are using cabinets deeper than 24"
(610), the electrical supply for the oven and the electrical supply for the cooktop should be located in the adjacent right side cabinet as shown.
283/8"(721) COOKTOP
CUT-OUT WIDTH
33" (838) RECOMMENDED
CABINET WIDTH
30"min (762)
24" min
(610)
10"
(254)
31/2"(89)
E
COOKTOP
ELECTRICAL
LOCATION IN
ADJACENT RIGHT
SIDE CABINET
33/4"min (95)
43/4"min (121)
273/16"
(691)
E
E
5"
(127)
281/2"(724)
OVEN OPENING WIDTH
4"
(102)
OVEN ELECTRICAL
LOCATION WITHIN
OPENING APPLIES
ONLY TO CABINETS
DEEPER THAN 24"(610)
41/2"(114)
2"**
(51)
Installation of a 30" (762) induction cooktop above a 30" (762) L Series or E Series single oven.

Planning Information
New 30" (762) Induction Cooktop
MODEL CT30I/S
Dimensions in parentheses are in
millimeters unless otherwise specified. 7
MULTIPLE COOKTOP INSTALLATION
With Wolf's integrated modules, you have the
ultimate in customization. You can create your
own design by mixing and matching the various
components within this system. And when you
couple these modules with other cooktops
within the Wolf inventory you and your client will
truly understand freedom of choice.
Some Wolf integrated modules can be installed
together or with a 30" (762) or 36" (914)
cooktop. When multiple units are installed side
by side, the cut-out dimensions that are shown
in the illustration are derived by adding 11/4"(32)
additional space for each additional unit, to give
you your total cut-out width. Refer to the illus-
tration below for countertop cut-out dimensions
for installation of multiple cooktop units.
When two or more cooktops or modules are
installed together, an accessory filler strip is
recommended. Refer to Accessories on page 3.
Countertop cut-out dimensions for installation of multiple cooktop units.
IMPORTANT NOTE: When multiple cooktops
and/or modules are installed side by side, each
unit must have its own separate recommended
electrical circuit. When multiple gas cooktops
and/or modules are installed next to one
another, they can receive their gas supply from a
common line. However, each unit must have its
own regulator installed between the mainline
and the cooktop or module.
IMPORTANT NOTE: Review specifications for
each specific integrated module for installation
requirements and limitations. Refer to the
integrated modules section of our website,
wolfappliance.com.
21/2"min
(64)
FRONT OF COUNTERTOP
191/4"
(489)
CUT-OUT
DEPTH
291/4"(743)
TWO MODULES WIDTH
441/2"(1130) THREE MODULES WIDTH OR
441/4"(1124) 30" COOKTOP AND ONE MODULE
593/4"(1518) FOUR MODULES WIDTH OR
591/2"(1511) 30" COOKTOP AND TWO MODULES OR
501/4"(1276) 36" COOKTOP AND ONE MODULE
14"
(356)
CUT-OUT
WIDTH