Wolf ICBCG152TF/S User manual

CONTENTS
Orifice, 1.40 mm
Orifice, 1.64 mm
Orifice, .68 mm
Label set
External natural gas regulator
TOOLS REQUIRED
3/4" Socket
T-15 Torx bit
7 mm Socket
8 mm Socket
Clean gloves (pair)
Detergent solution (for leak testing)
These instructions describe reworking a Wolf
ICBCG152T/S or ICBCG152TF/S natural gas cooktop to
meet Australian specifications.
WARNING
To avoid serious burns and/or explosions, keep
combustibles away from the appliance whenever a flame
is present. Surfaces and components get hot during the
use of the appliance.
WARNING
Disconnect the product from the power source before
starting this procedure.
WARNING
Turn off the gas to the product at the supply source before
starting this procedure.
DISASSEMBLE THE UNIT
1Remove the burner grate.
2Remove both burner caps.
3Remove both burner assemblies.
4Remove the knobs.
5Remove the bezels.
6Remove the burner pan and glass panel.
REWORK THE UNIT TO AUSTRALIAN SPECIFICATIONS
1For the front (9.2K) burner:
a) Use an 8 mm socket to remove the main orifice
marked "158," along with its extension.
b) Use a 7 mm socket to install the 1.40 mm orifice
directly into the main orifice holder (without the
extension).
2For the rear (12K) burner:
a) Use an 8 mm socket to remove the main orifice
marked "184," along with its extension.
b) Use a 7 mm socket to install the 1.64 mm orifice
directly into the main orifice holder (without the
extension).
c) Use a 7 mm socket to remove the simmer orifice
marked "65."
d) Use a 7 mm socket to install the 0.68 mm orifice
into the simmer orifice holder.
Orifice extension
GAS LEAK TESTING
WARNING
Never test for a gas leak with a flame.
1Brush a liquid detergent solution onto all gas
connections, then open the gas valve.
2If bubbles appear, close the valve and adjust
connections.
3Check for leaks again.
4Clean off the detergent solution.
ICBCG152T(F)/S Natural Gas Australia Rework
wolfappliance.com 800.222.7820
9029038 REV A 05/2019 Page 1 of 2 *9029038$REV$A*

ATTACH THE LABELS
1Attach the rating label (MF083) to the base of the
unit.
2Attach the blue AGA Makers Warranty label to the
unit near the rating label.
3Attach a gas type label to the base of the unit. Verify
the gas type label matches the unit (natural gas or
propane).
4Place a gas type label on the unit package near the
model number label.
Example label positions (ICBMM15T/S for natural gas
shown)
REASSEMBLE THE UNIT
1Install the burner pan and glass panel.
2Install the bezels.
3Install the knobs.
4Install both burner assemblies.
5Install both burner caps.
6Install the burner grate.
UPDATE THE UNIT PACKAGE
1Remove the old use and care guide and installation
guide from the unit package.
2Place a new use and care guide and installation
guide in the unit package.
3Place the spare rating label in the unit package.
4Add the external natural gas regulator to the unit
package.
ICBCG152T(F)/S Natural Gas Australia Rework
wolfappliance.com 800.222.7820
Page 2 of 2