Woodard WDC-SEA-07CT User manual

SEAVIEW Coffee Table
WDC-SEA-07CT
Assembly Instructions
Step 1: Remove protective wrapping first. Then lay all parts on floor and identify all parts packed in
carton against attached parts list.
Step 2: Lay tabletop (A) upside down on floor, so bottom is facing up. Place a protective soft
material on floor before placing tabletop face down on floor.
Step 4: Make sure all bolts are aligned properly and tightened sufficiently. Then place bolt covers
over bolts. With a second person's assistance, turn the table over onto it's legs carefully, resting it
on a flat floor surface .
Step 3: Then attach each of four legs (B) to the bottom as shown in Photo 1, using Bolt(E) and
Washer (F) and Bolt cover(G). Attach Stretcher (C) to Leg (B) using Bolt (D) and Washer (F) and Bolt
Cover (G) as shown in Diagram 2.
NOTE: IT IS USER'S RESPONSIBILITY TO MAKE SURE ALL PARTS ARE ASSEMBLED AND
TIGHTENED PROPERLY AND SECURELY.
Diagram 1
Diagram 2
1 of 2

Diagram:
Diagram 3
2 of 2
Ref Part Name Part Image Qty Ref Part Name Part Image Qty
A Table Top 1 EBolt (Long) 8
B Leg Panel 4 F Washers 16
C Stretcher 1 G Bolt Cover 16
D Bolt (Short) 8 H Hex Wrench 1
WOODARD
Customer Service Hours
8:00am-5:00pm CST Monday to Friday
Phone: [phone] Fax: [phone]
PRINTED IN CHINA
2 of 2