Woodard FRANCHESCA WDC-FRA-48D User manual

FRANCHESCA Dining Table
WDC-FRA-48D
Assembly Instructions
Step 1: Remove protective wrapping first. Then lay all parts on floor and identify all parts packed
in carton against attached parts list.
Step 2: Lay tabletop (A) upside down on floor, so bottom is facing up. Place a protective soft
material on floor before placing tabletop face down on floor.
Step 4: Make sure all bolts are aligned properly and tightened sufficiently. Then place bolt covers
over bolts. With a second person's assistance, turn the table over onto it's legs carefully, resting it
on flat floor surface. Put umbrella hole cover on top as shown in Diagram 3.
Step 3: Then attach each of four legs (B) to the bottom as shown in Diagram 1, using Bolt(D) and
Washer (F) and Bolt cover(G). Attach Stretcher (C) to Leg (B) using Bolt (E) and Washer (F) and Bolt
Cover (G) as shown in Diagram 2.
NOTE: IT IS USER'S RESPONSIBILITY TO MAKE SURE ALL PARTS ARE ASSEMBLED AND
TIGHTENED PROPERLY AND SECURELY.
Diagram 1
G
D
F
A
B
G
D
F
A
B
1 of 2

Diagram 2 Diagram 3
A
H
A
BC
GEF
2 of 2
Ref Part Name Part Image Qty Ref Part Name Part Image Qty
A Table Top 1 F Washer(M6) 16
B Table Leg 4 G Bolt Cover 16
C Stretcher 1 H Umbrella hole
cover 1
D Bolt (short) 8 IHex Wrench 1
EBolt (long) 8
WOODARD
Customer Service Hours
8:00am-5:00pm CST Monday to Friday
PARTS LIST:
A
H
A
BC
GEF
PRINTED IN CHINA
pyy
Phone: [phone] Fax: [phone]
A
H
A
BC
GEF
2 of 2