Woodendot Alada User manual

ASSEMBLY INSTRUCTIONS
Alada
Warning!
Do not lean on desk.
Warning!
Max Weight: 20 kg
You will need a manual drill
for the wall holes
We recommend two people
for the installation
The drill bit required is Ø 6 mm or 15/64”
Depth of the hole in wall: 50 mm / 1.96”
For the hole to be the exact depth, measure 50mm/1.96”
on the drill bit and place tape around it to mark the
distance. Stop drilling when it reaches that depth.
1x
1x
1x
(B) 7x
(A) 7x (C) 12x
(D) 4x (E) 4x
1x

Use the level tool
Mark the holes with a pencil
(C)
2º
Use the level tool
Mark the height with a pencil
*Recomended height for standard seat height*
1º
69 cm*
3º
(A)
(B)
4º
(D)
(E)
Insert the four bolts through the hinge,
wood and metal structure
Tighten the nuts and washers in the bottom side 5º Fold the desk and secure it with
the wooden stopper marked 6º
Secure the wooden desk
with the remaining screws
Assemble the metal structure to
the wall using anchors and screws
(F)
The stability of the Alada desk is highly dependent
on the wall. On some fragile walls a chemical anchor
(not included) can be used to reinforce the wall.