Woodendot Alba Floating nightstand User manual

Alba Floating nightstand
ASSEMBLY INSTRUCTIONS

2 DIFFERENT POSSIBILITIES
4 DIFFERENT POSSIBILITIES
1x OR
1x 1x 1x 1x
6x 1x1x
7x 11x
(A) (D) (B) (C) (E)
1x
You will need a manual drill
for the wall holes
We recommend two people
for the installation
For the hole to be the exact depth, measure 50mm/1.96”
on the drill bit and place tape around it to mark the
distance. Stop drilling when it reaches that depth.
The drill bit required is Ø 6 mm or 15/64”
Depth of the hole in wall: 50 mm / 1.96”

1º
Use the level tool
Mark the holes with a pencil
(A)
2º
4º
3º
(B)
Place the “U” piece between the
wall and the back panel.
Mark the three holes with a pencil
5º
6º
7º
8º
Screw the “U” piece to the back
panel (x2 screws)
(C)
Make the hole in the wall
9º
(A)
10º
11º
Screw the “U” piece to the wall
with the help of the Allen key.
Screw the table cover
13º
12º
(E)
(D)

14º
Introduce the small
wooden piece
15º
Make a line at the intersection of
the small piece of wood on the
back
16º Take out the
small
wooden piece
Screw on the L-shaped metal
piece using the marked line
17º
(C)
18º Introduce the small wooden piece
with the metal piece towards the
back
Screw to the set
19º
(C)