Woodendot Cielo Shelf User manual

ASSEMBLY INSTRUCTIONS
Cielo Shelf

Package contains
S - 21cm / 8.3”
M - 34cm / 13.4”
L - 41cm / 16.2”
Drill the holes in the wall and insert the shelf supports.
You may use the manual drill to tighten the shelf supports.
Insert the shelf into the shelf supports that are now
fixed to the wall. The shelf is held in place by pressure.
If necessary, give small taps to secure its position.
We recommend two people
for the installation
For the hole to be the exact depth, measure 50 mm / 1.97”
on the drill bit and place tape around it to mark the
distance. Stop drilling when it reaches that depth.
You will need a manual drill
for the wall holes
The drill bit required is Ø 12 mm or 15/32”
Depth of the hole in the wall: 50 mm / 1.97”
1º
3º
2º
X*
2x
The stability of the Cielo shelf depends highly
on the wall composition. Some fragile walls
may require reinforcement (not included).
Hold the shelf to the wall and use the level tool to make sure it is horizontal.
Draw two horizontal lines at the ends of the shelf to mark the angle.
Put the shelf aside.
Measure the distance X* depending on the size of your
shelf to know where you'll drill the screw holes.